Two-switch ZCS totem-pole bridgeless PFC boost rectifier
- 1 December 2012
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Abstract
In this paper, a new two-switch zero current switching (ZCS) bridgeless boost rectifier with high power factor (PF) is proposed. The proposed bridgeless converter is based on a totem-pole configuration which allows the current to flow from high side to low side and vice versa during resonance. Hence, no auxiliary switch is needed to provide soft switching for all semiconductor devices. An average current mode controlled is employed to provide high PF and smooth input current waveform. A detailed analysis of the converter operations and controls are presented.Keywords
This publication has 12 references indexed in Scilit:
- New zero-voltage-switching bridgeless PFC, using an improved auxiliary circuitIET Power Electronics, 2011
- Advance battery charger topology using SPMC incorporating active power filter2010
- Bridgeless Single-Stage Full-Bridge Converter with One Cycle Control in the output voltage2010
- An Interleaved Totem-Pole Boost Bridgeless Rectifier With Reduced Reverse-Recovery Problems For Power Factor CorrectionIEEE Transactions on Power Electronics, 2010
- Zero-Current-Transition Bridgeless PFC Without Extra Voltage and Current StressIEEE Transactions on Industrial Electronics, 2009
- Bridgeless Boost Rectifier With Low Conduction Losses and Reduced Diode Reverse-Recovery ProblemsIEEE Transactions on Industrial Electronics, 2007
- Performance Evaluation of Bridgeless PFC Boost RectifiersAPEC 07 - Twenty-Second Annual IEEE Applied Power Electronics Conference and Exposition, 2007
- A Novel Zero-Voltage-Switching PWM Boost Rectifier With High Power Factor and Low Conduction LossesIEEE Transactions on Industrial Electronics, 2005
- Single phase power factor correction: a surveyIEEE Transactions on Power Electronics, 2003
- Circuit topologies for PWM boost rectifiers operated from 1-phase and 3-phase AC supplies and using either single or split DC rail voltage outputs1995