Nanocrystalline structures and tensile properties of stainless steels processed by severe plastic deformation
Open Access
- 8 August 2014
- conference paper
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 63 (1) , 012156
Abstract
The development of nanocrystalline structures in austenitic stainless steels during large strain cold rolling and their tensile behavior were studied. The cold rolling to total equivalent strains above 2 was accompanied by the evolution of nanocrystalline structures with the transverse grain size of about 100 nm. The development of deformation twinning and martensitic transformation during cold working promoted the fast kinetics of structural changes. The development of nanocrystalline structures resulted in significant strengthening. More than fourfold increase in the yield strength was achieved. The strengthening of nanocrystalline steels after severe plastic deformation was considered as a concurrent operation of two strengthening mechanisms, which were attributed to grain size and internal stress. The contribution of internal stresses to the yield strength is comparable with that from grain size strengthening.Keywords
This publication has 18 references indexed in Scilit:
- Dynamic and post-dynamic recrystallization under hot, cold and severe plastic deformation conditionsProgress in Materials Science, 2014
- Extreme grain refinement by severe plastic deformation: A wealth of challenging scienceActa Materialia, 2013
- Effect of large strain cold rolling and subsequent annealing on microstructure and mechanical properties of an austenitic stainless steelMaterials Science and Engineering: A, 2012
- Evolution of grain and subgrain structure during cold rolling of commercial-purity titaniumMaterials Science and Engineering: A, 2011
- Using high-pressure torsion for metal processing: Fundamentals and applicationsProgress in Materials Science, 2008
- ARB (Accumulative Roll‐Bonding) and other new Techniques to Produce Bulk Ultrafine Grained MaterialsAdvanced Engineering Materials, 2003
- Bulk nanostructured materials from severe plastic deformationProgress in Materials Science, 2000
- Developing stable fine–grain microstructures by large strain deformationPhilosophical Transactions of the Royal Society A: Mathematical, Physical and Engineering Sciences, 1999
- The effect of grain size on the shock-loading response of 304-type stainless steelMetallurgical Transactions A, 1976
- The martensite transformation in 18% Cr-8% Ni steelsActa Metallurgica, 1964