Three-Dimensional Transient Heat Conduction Equation Solution for Accurate Determination of Heat Transfer Coefficient
Authors:
- 17 March 2020
- journal article
- research article
- Published by Wiley in Journal of Heat Transfer
- Vol. 142 (5)
Abstract
Accurate quantification of local heat transfer coefficient (HTC) is imperative for design and development of heat exchangers for high heat flux dissipation applications. Liquid crystal and infrared thermography (IRT) are typically employed to measure detailed surface temperatures, where local HTC values are calculated by employing suitable conduction models, e.g., one-dimensional (1D) semi-infinite conduction model on a material with the low thermal conductivity and low thermal diffusivity. Often times, this assumption of 1D heat diffusion and ignoring its associated lateral conduction effects leads to significant errors in HTC determination. Prior studies have identified this problem and quantified the associated errors in HTC determination for some representative cooling concepts, by accounting for lateral heat diffusion. In this paper, we have presented a procedure for solution of three-dimensional (3D) transient conduction equation using alternating direction implicit (ADI) method and an error minimization routine to find accurate HTCs at relatively lower computational cost. Representative cases of a single jet and an array jet impingement under maximum crossflow condition have been considered here, for IRT and liquid crystal thermography, respectively. Results indicate that the globally averaged HTC obtained using the 3D model was consistently higher than the conventional 1D model by 7–14%, with deviation levels reaching as high as 20% near the stagnation region. Proposed methodology was computationally efficient and is recommended for studies aimed toward local HTC determination.Keywords
This publication has 33 references indexed in Scilit:
- A transient liquid crystal method using a 3-D inverse transient conduction schemeInternational Journal of Heat and Mass Transfer, 2002
- Detailed heat transfer distributions in two-pass square channels with rib turbulatorsInternational Journal of Heat and Mass Transfer, 1997
- Film Effectiveness Over a Flat Surface With Air and CO2 Injection Through Compound Angle Holes Using a Transient Liquid Crystal Image MethodJournal of Turbomachinery, 1997
- A New Hue Capturing Technique for the Quantitative Interpretation of Liquid Crystal Images Used in Convective Heat Transfer StudiesJournal of Turbomachinery, 1992
- Entrainment Effects on Impingement Heat Transfer: Part II—Local Heat Transfer MeasurementsJournal of Heat Transfer, 1985
- Visualization of heat transfer from arrays of impinging jetsInternational Journal of Heat and Mass Transfer, 1982
- Impingement of a circular jet with and without cross flowInternational Journal of Heat and Mass Transfer, 1982
- Periodic Streamwise Variations of Heat Transfer Coefficients for Inline and Staggered Arrays of Circular Jets with Crossflow of Spent AirJournal of Heat Transfer, 1980
- Heat Transfer by a Square Array of Round Air Jets Impinging Perpendicular to a Flat Surface Including the Effect of Spent AirJournal of Engineering for Power, 1970
- A general formulation of alternating direction methodsNumerische Mathematik, 1964