Reutilizing Single-Use Surgical Face Masks to Improve the Mechanical Properties of Concrete: A Feasibility Study
Open Access
- 2 April 2023
- journal article
- research article
- Published by Engineering, Technology & Applied Science Research in Engineering, Technology & Applied Science Research
- Vol. 13 (2) , 10511-10516
Abstract
The coronavirus outbreak (COVID-19) has caused a sharp increase in the use of Single-Use Surgical Face Masks (SUSFMs) as personal protective equipment. These eventually end up in waste disposal facilities causing environmental pollution. Those that end up in the water bodies fragment into microplastics that affect marine life. Since the SUSFM materials are made from polypropylene, a thermoplastic polymer material that takes a long time to degrade, it is important to develop sustainable mitigation measures to remove them from the environment. This study investigated the feasibility of reutilizing SUSFMs in concrete. SUSFMs were shredded and added to C30/37 grade concrete in various percentages, 0%, 0.5%, 1.0%, 1.5%, 2.0%, 2.5%, and 3.0%, by mass of cement content. The specimens were cured for 28 days before being tested for compressive strength, splitting tensile strength, and ultrasonic pulse velocity. The compressive strength decreased with an increase in the length and dosage content. The least decrease of 10.4% was observed at 0.5% content of 30mm length of SUSFM material. The results showed that concrete improved regarding splitting tensile strength, with the highest increase of 15.2% at 0.5% content of 30mm SUSFM. In addition, the overall quality of concrete remains at UPV values of more than 4000m/s registering good quality concrete. The results underscore the use SUSFM material in concrete in order to improve its quality while at the same time reducing waste.Keywords
This publication has 18 references indexed in Scilit:
- Improper solid waste management increases potential for COVID-19 spread in developing countriesResources, Conservation and Recycling, 2020
- Decontamination of surgical face masks and N95 respirators by dry heat pasteurization for one hour at 70°CAmerican Journal of Infection Control, 2020
- Ultraviolet germicidal irradiation: Possible method for respirator disinfection to facilitate reuse during the COVID-19 pandemicJournal of the American Academy of Dermatology, 2020
- Characteristics of Recycled Polypropylene Fibers as an Addition to Concrete Fabrication Based on Portland CementMaterials, 2020
- Performance of dioctyl terephthalate concrete2019
- Influence of Fibre Length on the Behaviour of Polypropylene Fibre Reinforced Cement ConcreteCivil Engineering Journal, 2018
- The possibility of enhancing some properties of self-compacting concrete by adding waste plastic fibersJournal of Building Engineering, 2016
- Evaluating plastic shrinkage and permeability of polypropylene fiber reinforced concreteInternational Journal of Sustainable Built Environment, 2016
- Enhancement of mechanical properties in polypropylene– and nylon–fibre reinforced oil palm shell concreteMaterials & Design (1980-2015), 2013
- Properties of concrete reinforced with different kinds of industrial waste fibre materialsConstruction and Building Materials, 2009