Production of Solidified Body from a Melt and Its Electrical Conductivity of CsSnBr3 Using Precursor Prepared by Mechanochemical Reaction Process
Open Access
- 15 October 2023
- journal article
- research article
- Published by Japan Society of Powder and Powder Metallurgy in Journal of the Japan Society of Powder and Powder Metallurgy
- Vol. 70 (10) , 427-431
Abstract
Cesium-tin-bromide perovskite (CsSnBr3) has focused on as a candidate material for all-inorganic perovskite solar cell and thermoelectric energy converter because of its optical, electrical, and thermal properties. On the other hand, the electrical properties have not been clarified yet because of several inconsistent reports. In this paper, we produced CsSnBr3 bulk from a melt using the precursor powder prepared by a mechanochemical process. From powder X-ray diffraction analysis, main phase of the precursor was CsSnBr3 perovskite, and minor impurities were Cs4SnBr6 and CsSn2Br5. Although main phase of the bulk produced from a melt was CsSnBr3, small amount impurity, CsSn2Br5 was confirmed. From the electrical conductivity (σt) measurement, irreversible temperature dependence of σt was observed at first time increasing temperature. The conductivity measured from room temperature to 443 K at the first time showed metallic behavior. On the other hand, the temperature dependence is changed into opposite with decreasing temperature. At this operation, σt decrease with decreasing temperature. This semiconductor like behavior was found to be reversible after first increasing temperature operation. These results indicate that post anneal as well as production process of CsSnBr3 would be important to control its electric property.Keywords
This publication has 15 references indexed in Scilit:
- Dynamic Stereochemical Activity of the Sn2+ Lone Pair in Perovskite CsSnBr3Journal of the American Chemical Society, 2016
- Research and Development of the Coprecipitation Process for Lanthanum Germanate OxyapatiteJournal of the American Ceramic Society, 2014
- Development of New Synthesis Route of Lanthanum Germanate Oxyapatite from Homogeneous Aqueous Solution2014
- Low-Tepmerature Synthesis Process of Lanthanum Germanate Oxyapatite by Citrate Combustion MethodJournal of the Japan Society of Powder and Powder Metallurgy, 2014
- High Pressure Study of NH4Pb2Br5 Type Compounds. I Structural Parameters and Their Evolution under High PressureZeitschrift für anorganische und allgemeine Chemie, 2004
- Transport properties of the perovskite-type halidesMaterials Letters, 1991
- Structural Phase Transition and Electrical Conductivity of the Perovskite CH3NH3Sn1-xPbxBr3 and CsSnBr3Bulletin of the Chemical Society of Japan, 1990
- An X-ray study of successive phase transitions in CsSnBr3Journal of Physics C: Solid State Physics, 1986
- Solid-state properties of materials of the type Cs4MX6(where M = Sn or Pb and X = Cl or Br)J. Chem. Soc., Dalton Trans., 1983
- Luminescence and electrical conductivity of CsSnBr3, and related phasesJournal of Physics and Chemistry of Solids, 1981