Petrophysical properties of the Green Canyon Block 955 hydrate reservoir inferred from reconstituted sediments: Implications for hydrate formation and production
Authors:
- 15 September 2020
- journal article
- research article
- Published by American Association of Petroleum Geologists AAPG/Datapages in AAPG Bulletin
- Vol. 104 (9) , 1997-2028
Abstract
We explore the petrophysical behavior of the two interbedded lithofacies (sandy silt and clayey silt) that constitute the Green Canyon Block 955 hydrate reservoir in the deep-water Gulf of Mexico by performing experiments on reconstituted samples of the reservoir material. Sandy silts reconstituted to the in situ porosity have a permeability of 11.8 md (1.18 × 10−14 m2), which is similar to the intrinsic permeabilities measured in intact cores from hydrate reservoirs of similar grain size offshore Japan (Nankai Trough) and offshore India. Reconstituted clayey silts have a much lower intrinsic permeability of 3.84 × 10−4 md (3.84 × 10−19 m2) at the in situ stress. The reconstituted sandy silt is less compressible than the clayey silt. Mercury injection capillary pressure measurements demonstrate that the largest pores with the clayey silt are still smaller than the pores remaining after 90% hydrate saturation in sandy silt. We interpret that the methane solubility in pores of clayey silt is always less than that necessary to form hydrate, which explains why no hydrate is present in the clayey silt. We upscale the reservoir properties to estimate the behavior of interbedded sandy silt and clayey silt. We find the upscaled intrinsic horizontal and vertical permeabilities for the entire reservoir interval are 8.6 md (8.6 × 10−15 m2) and 1.4 × 10−3 md (1.4 × 10−18 m2). We estimate that during reservoir production, a maximum vertical strain of approximately 12% will result. Ultimately, this study will inform reservoir simulation models with petrophysical properties at scales of both individual lithofacies and reservoir formation.Keywords
This publication has 66 references indexed in Scilit:
- Depressurization‐Induced Fines Migration in Sediments Containing Methane Hydrate: X‐Ray Computed Tomography Imaging ExperimentsJournal of Geophysical Research: Solid Earth, 2018
- Pressure and Stress Prediction in the Nankai Accretionary Prism: A Critical State Soil Mechanics Porosity‐Based ApproachJournal of Geophysical Research: Solid Earth, 2018
- Glacial Cycles Influence Marine Methane Hydrate FormationGeophysical Research Letters, 2018
- In situ stress state and strength in mudrocksJournal of Geophysical Research: Solid Earth, 2016
- Comparison between grain-size analyses using laser diffraction and sedimentation methodsBiosystems Engineering, 2010
- Geotechnical Laboratory Measurements for Engineers2009
- Methane hydrate formation in turbidite sediments of northern Cascadia, IODP Expedition 311Earth and Planetary Science Letters, 2008
- Effects of geologic time on the initial stiffness of claysEngineering Geology, 2007
- Passing gas through the hydrate stability zone at southern Hydrate Ridge, offshore OregonEarth and Planetary Science Letters, 2006
- Formulation of a unified constitutive model for clays and sandsInternational Journal for Numerical and Analytical Methods in Geomechanics, 1999