Effects of Post-Injection Strategies on Near-Injector Over-Lean Mixtures and Unburned Hydrocarbon Emission in a Heavy-Duty Optical Diesel Engine
- 12 April 2011
- journal article
- Published by SAE International in SAE International Journal of Engines
- Vol. 04 (1) , 1978-1992
Abstract
Post-injection strategies aimed at reducing engine-out emissions of unburned hydrocarbons (UHC) were investigated in an optical heavy-duty diesel engine operating at a low-load, low-temperature combustion (LTC) condition with high dilution (12.7% intake oxygen) where UHC emissions are problematic. Exhaust gas measurements showed that a carefully selected post injection reduced engine-out load-specific UHC emissions by 20% compared to operation with a single injection in the same load range. High-speed in-cylinder chemiluminescence imaging revealed that without a post injection, most of the chemiluminescence emission occurs close to the bowl wall, with no significant chemiluminescence signal within 27 mm of the injector. Previous studies have shown that over-leaning in this near-injector region after the end of injection causes the local equivalence ratio to fall below the ignitability limit. With a carefully selected post-injection, mixtures close to the injector show significant chemiluminescence emission, indicating more complete combustion of those regions, likely due to increased local equivalence ratios.Simultaneous planar laser-induced fluorescence (PLIF) of OH with 284-nm excitation and PLIF of combined formaldehyde and poly aromatic hydrocarbons (PAH) with 355-nm excitation were employed to identify the regions of first- and second-stage ignition, as well as providing some indication of local equivalence ratios. The laser diagnostics show that without a post injection, regions close to the injector show formaldehyde fluorescence late in the cycle without detectable OH fluorescence, indicating that these regions do not achieve second-stage ignition, and therefore likely contribute to UHC emissions. Persistence of formaldehyde fluorescence late in the cycle is also consistent with fuel-lean mixtures. With a carefully selected post injection, strong OH fluorescence appears in the near-injector regions, indicating that they are likely enriched by the post-injection such that they reach second-stage ignition and more complete oxidation. The reduction observed in the exhaust UHC emission is therefore attributed to the enrichment mechanism of the near-injector regions by the close-coupled post-injection.Keywords
This publication has 18 references indexed in Scilit:
- Development of a Fuel Injection Strategy for Partially Premixed Compression Ignition CombustionSAE International Journal of Engines, 2009
- Sources of Hydrocarbon Emissions from Low-Temperature Premixed Compression Ignition Combustion from a Common Rail Direct Injection Diesel EngineCombustion Science and Technology, 2009
- Gas Density and Rail Pressure Effects on Diesel Spray Growth from a Heavy-Duty Common Rail InjectorEnergy & Fuels, 2008
- Effects of Piston Bowl Geometry on Mixture Development and Late-Injection Low-Temperature Combustion in a Heavy-Duty Diesel EngineSAE International Journal of Engines, 2008
- In-cylinder unburned hydrocarbon visualization during low-temperature compression-ignition engine combustion using formaldehyde PLIFProceedings of the Combustion Institute, 2007
- On the Correlation between NOx Emissions and the Diesel Premixed BurnSAE International Journal of Advances and Current Practices in Mobility, 2004
- Simultaneous OH- and Formaldehyde-LIF Measurements in an HCCI EngineSAE International Journal of Advances and Current Practices in Mobility, 2003
- Piston-Liner Crevice Geometry Effect on HCCI Combustion by Multi-Zone AnalysisSAE International Journal of Advances and Current Practices in Mobility, 2002
- Effects of Fuel Parameters and Diffusion Flame Lift-Off on Soot Formation in a Heavy-Duty DI Diesel EngineSAE International Journal of Advances and Current Practices in Mobility, 2002
- Laser techniques for the quantitative detection of reactive intermediates in combustion systemsProgress in Energy and Combustion Science, 1994