Current status and applications of hybrid micro-machining processes: A review
- 2 September 2014
- journal article
- review article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture
- Vol. 229 (10) , 1681-1693
Abstract
The hybrid micro-machining process employs simultaneous or ensuing action of two or more machining processes or takes aid of some energy assistance in material removal to enhance advantages and minimize potential disadvantages found in individual material removal techniques. There are various examples, such as abrasive electro-discharge grinding, electrochemical discharge machining, laser-assisted turning, and jet-assisted machining. This article presents a novel classification of and reviews the past and present research and applications of the hybrid micro-machining process, highlighting its effects on response variables such as material removal rate, tool wear, and surface roughness. Although hybrid micro-machining has been an active research area in non-conventional and critical machining since few years, insufficient knowledge about capabilities in sizes, materials, machinery, and manipulating devices is still a major constraint in the development of these processes. In the near future, there is ample scope for the hybrid micro-machining process in exploring issues in material removal at micro-scale, effect of residual stresses, and environment.Keywords
This publication has 71 references indexed in Scilit:
- Analysis of Residual Stresses in Sustainable Cryogenic Machining of Nickel Based Alloy—Inconel 718Journal of Manufacturing Science and Engineering, 2011
- Sequential Laser Mechanical Microdrilling of Inconel 718 AlloyJournal of Manufacturing Science and Engineering, 2011
- Machinability improvement of titanium alloy (Ti–6Al–4V) via LAM and hybrid machiningInternational Journal of Machine Tools and Manufacture, 2010
- Investigation of machining performance in high-pressure jet assisted turning of Inconel 718: An experimental studyInternational Journal of Machine Tools and Manufacture, 2009
- Machining characteristics of magnetic force-assisted EDMInternational Journal of Machine Tools and Manufacture, 2008
- A review on current research trends in electrical discharge machining (EDM)International Journal of Machine Tools and Manufacture, 2007
- An investigation of ultrasonic-assisted electrical discharge machining in gasInternational Journal of Machine Tools and Manufacture, 2006
- Development of an abrasive jet machining system assisted by two fluidized beds for internal polishing of circular tubesInternational Journal of Machine Tools and Manufacture, 2006
- Pin-plate micro assembly by integrating micro-EDM and Nd-YAG laserInternational Journal of Machine Tools and Manufacture, 2002
- Plasma enhanced machining of Inconel 718: modeling of workpiece temperature with plasma heating and experimental resultsInternational Journal of Machine Tools and Manufacture, 2001