Single Nickel Atom Catalysts Enable Fast Polysulfide Redox for Safe and Long‐Cycle Lithium–Sulfur Batteries
Authors:
Abstract
Lithium–sulfur (Li–S) batteries have attracted great interest due to their low cost, high theoretical energy density, and environmental friendliness. However, the sluggish conversion of lithium polysulfides (LiPS) to S and Li2S during the charge/discharge process leads to unsatisfactory rate performance of lower to 0.1 C (1 C = 1675 mA g−1) especially for Li‐S pouch batteries, thus hindering their practical applications in high power batteries. Here, well‐defined and monodispersed Ni single‐atom catalysts (SACs) embedded in highly porous nitrogen‐doped graphitic carbons (NiSA‐N‐PGC) are designed and synthesized to form Ni–N4 catalytic sites at the atomic level. When serving as a bifunctional electrocatalyst, the Ni−N4 catalytic sites cannot only promote the interfacial conversion redox of LiPS by accelerating the transformation kinetics, but also suppress the undesirable shuttle effect by immobilizing LiPS. These findings are verified by both experimental results and DFT theoretical calculations. Furthermore, Li ions show low diffusion barrier on the surface of Ni−N4 sites, resulting in enhanced areal capacity of batteries. As a result, the Li–S battery delivers stable cycling life of more than 600 cycles with 0.069% capacity decay per cycle at a rate of 0.5 C. More importantly, the Li–S pouch cells with NiSA‐N‐PGC show an initial capacity of 1299 mAh g−1 at a rate of 0.2 C even with high sulfur loading of 6 mg cm−2. This work opens up an avenue for developing single‐atom catalysts to accelerate the kinetic conversion of LiPS for highly stable Li–S batteries.Keywords
Funding Information
- National Natural Science Foundation of China (52202215, 52003038, 52102307, 51972042)
This publication has 49 references indexed in Scilit:
- A review on the status and challenges of electrocatalysts in lithium-sulfur batteriesEnergy Storage Materials, 2019
- Manipulating kinetics of sulfurized polyacrylonitrile with tellurium as eutectic accelerator to prevent polysulfide dissolution in lithium-sulfur battery under dissolution-deposition mechanismNano Energy, 2019
- Cobalt in Nitrogen-Doped Graphene as Single-Atom Catalyst for High-Sulfur Content Lithium–Sulfur BatteriesJournal of the American Chemical Society, 2019
- Non defect-stabilized thermally stable single-atom catalystNature Communications, 2019
- Single-Atom Catalysts: Synthetic Strategies and Electrochemical ApplicationsJoule, 2018
- Atomically dispersed Ni(i) as the active site for electrochemical CO2 reductionNature Energy, 2018
- Modified Separator Performing Dual Physical/Chemical Roles to Inhibit Polysulfide Shuttle Resulting in Ultrastable Li–S BatteriesACS Nano, 2017
- Catalytic Effects in Lithium–Sulfur Batteries: Promoted Sulfur Transformation and Reduced Shuttle EffectAdvanced Science, 2017
- Inhibiting Polysulfide Shuttle in Lithium–Sulfur Batteries through Low‐Ion‐Pairing Salts and a Triflamide SolventAngewandte Chemie International Edition, 2017
- Single‐Atom Catalyst of Platinum Supported on Titanium Nitride for Selective Electrochemical ReactionsAngewandte Chemie International Edition, 2015