Phase Transformation Contributions to Heat Capacity and Impact on Thermal Diffusivity, Thermal Conductivity, and Thermoelectric Performance
- 3 July 2019
- journal article
- research article
- Published by Wiley in Advanced Materials
- Vol. 31 (35) , e1902980
Abstract
The accurate characterization of thermal conductivity κ, particularly at high temperature, is of paramount importance to many materials, thermoelectrics in particular. The ease and access of thermal diffusivity D measurements allows for the calculation of κ when the volumetric heat capacity, ρcp, of the material is known. However, in the relation κ = ρcpD, there is some confusion as to what value of cp should be used in materials undergoing phase transformations. Herein, it is demonstrated that the Dulong–Petit estimate of cp at high temperature is not appropriate for materials having phase transformations with kinetic timescales relevant to thermal transport. In these materials, there is an additional capacity to store heat in the material through the enthalpy of transformation ΔH. This can be described using a generalized model for the total heat capacity for a material where φ is an order parameter that describes how much latent heat responds “instantly” to temperature changes. Here, Cpφ is the intrinsic heat capacity (e.g., approximately the Dulong–Petit heat capacity at high temperature). It is shown experimentally in Zn4Sb3 that the decrease in D through the phase transition at 250 K is fully accounted for by the increase in cp, while κ changes smoothly through the phase transition. Consequently, reports of κ dropping near phase transitions in widely studied materials such as PbTe and SnSe have likely overlooked the effects of excess heat capacity and overestimated the thermoelectric efficiency, zT.Keywords
Funding Information
- U.S. Department of Commerce (70NANB19H005)
- National Institute of Standards and Technology
- Solid-State Solar Thermal Energy Conversion, Massachusetts Institute of Technology
- U.S. Department of Energy (DE‐SC0001299/DE‐FG02‐09ER46577)
This publication has 58 references indexed in Scilit:
- Thermal Conductivity during Phase TransitionsAdvanced Materials, 2018
- Heat capacity of Mg3Sb2, Mg3Bi2, and their alloys at high temperatureMaterials Today Physics, 2018
- Assessing the Thermal Conductivity of Cu2−xSe Alloys Undergoing a Phase Transition via the Simultaneous Measurement of Thermoelectric Parameters by a Harman-Based SetupJournal of Electronic Materials, 2018
- Elastic properties, thermal stability, and thermodynamic parameters of MoAlBPhysical Review B, 2017
- Apparent critical phenomena in the superionic phase transition of Cu2-xSeNew Journal of Physics, 2016
- Measuring thermoelectric transport properties of materialsEnergy & Environmental Science, 2014
- Phase transition enhanced thermoelectric figure-of-merit in copper chalcogenidesAPL Materials, 2013
- Ultrahigh Thermoelectric Performance by Electron and Phonon Critical Scattering in Cu2Se1‐xIxAdvanced Materials, 2013
- Transport Properties of Bulk Thermoelectrics: An International Round-Robin Study, Part II: Thermal Diffusivity, Specific Heat, and Thermal ConductivityJournal of Electronic Materials, 2013
- Complex thermoelectric materialsNature Materials, 2008