Response Surface Optimization Design for High-Speed Ball Bearing Double-Lip Seals Considering Wear Characteristics
Open Access
- 1 August 2025
- journal article
- research article
- Published by MDPI AG in Lubricants
- Vol. 13 (8) , 343
Abstract
This paper focuses on the sealing failure problem of double-lip seal rings for high-speed ball bearings used in unmanned aerial vehicles. By using ANSYS 2023R1 software, a thermal–stress–wear coupled finite element model was established. Taking the contact pressure and volume loss due to wear as indicators to evaluate sealing performance, this study analyzed the influence of lip seal structural parameters on sealing performance, performed response surface optimization of the seal structure parameters and conducted a comparative test on lip seals before and after optimization. The research results show that the contact pressure at the main lip of the lip seal was the greatest, which was 0.79 MPa, and the volume loss due to wear lip seal was 7.94 × 10−7 mm3. Optimal sealing performance is achieved when the seal lip inclination angle is 41.68°, the middle width of the lip seal is 0.153 mm, the main lip height is 0.179 mm, the spring center distance is 0.37 mm and the radial interference is 0.0034 mm. After optimization, the grease leakage rate of the sealing ring decreased by 48% compared to before optimization.Keywords
Funding Information
- Key R&D Plan of Ningbo City (2023Z006, 2023T016)
- Ningbo City Unveiled Project (2023Z006, 2023T016)
This publication has 22 references indexed in Scilit:
- A novel waste heat-driven methane reforming membrane reactor and parametric optimization study combining CFD simulation and response surface methodologyCase Studies in Thermal Engineering, 2025
- Effect of angle eccentricity on lip seal performance of helicopter gearboxTribology International, 2025
- An analytical model for stress distribution of NBR O-ring during dynamic hydrogen permeationInternational Journal of Hydrogen Energy, 2025
- An active learning reliability method combining population Monte Carlo and Kriging model for small failure probabilityStructures, 2024
- The sealing performance of PTFE O-rings at low temperatureJournal of Physics: Conference Series, 2024
- An improved mixed lubrication model for revealing the mechanism of high speed and frictional heat on sealing performanceTribology International, 2023
- Thermal-stress-wear coupled characteristics of oil seal in airframe rod end-bearingTribology International, 2021
- Prediction of seal wear with thermal–structural coupled finite element methodFinite Elements in Analysis and Design, 2014
- Hydrodynamic effects of shaft surface roughness on rotary lip seal behaviourSealing Technology, 2003
- A Theory of Large Elastic DeformationJournal of Applied Physics, 1940