Abstract
Green hydrogen is a promising energy carrier as it has a high energy density, and it can be produced in high purity from water via electrolysis. While proton exchange membrane (PEM) electrolysers have been developed, they require noble metal catalysts to survive the corrosive acidic environment in the cell, hence the prohibitively high cost of this technology has hindered its commercial implementation. Anion exchange membrane (AEM) electrolysers are a rapidly improving technology, which combine the advantages of alkaline water and PEM electrolysers, i.e. they are compact, utilise cost effective non-noble metal catalysts and operate under mild conditions, making them viable alternatives to PEM. 1 The composition of the anion exchange polyelectrolytes (AEPs) used as membranes and ionomers in these devices can be fine-tuned to control ion conductivity, ion exchange capacity, and water uptake and swelling. 2 This requires careful design of the cationic head group, the polymer backbone, the tether and the co-monomer. Despite the advantages of AEM based devices, balancing the long-term thermal stability and efficiency of AEPs at high pH remains a major challenge which needs to be addressed if AEM electrolysers are to become commercially competitive with existing hydrogen production systems. 3-5 Building upon previous studies, which have demonstrated the choice of cation-polymer tether is a major component in controlling alkaline stability, this work explores a bottom-up approach to the design of a new subset of polystyrene based quaternary ammonium (QA) monomers for use as AEPs. 6 A series of QA monomers were prepared either by Buchwald-Hartwig amination or reductive amination, followed by cyclisation using 1,5-dibromopentane. Alkaline stability studies were carried out over 30 days at 80 °C, using 1 H NMR spectroscopy to monitor the extent of QA degradation. To rationalise the experimentally observed degradation, computational studies were conducted to investigate the potential degradation pathways at different hydration levels and determine the corresponding activation parameters. The calculated activation energies support the observed degradation trends, providing justification to the order of stability of QA monomers under chosen conditions. Analysis concluded that increasing the number of ‘spacer’ units between the phenyl ring of the styrene and the QA centre led to a dramatic improvement in alkaline stability, with the most stable QA monomers displaying half-lives competitive with the most stable head groups reported in the literature under the same conditions. Inclusion of the electronegative nitrogen in the tether was found to cause a decrease in stability, despite the group being a necessary component to synthesise polymerizable QA monomers. The most stable QA monomer, which has an impressive half-life in excess of 30,000 h at 80 °C in 3M NaOD, was selected for the synthesis of AEPs to ascertain their suitability for use in AEM electrolysers. H. D. Abruña, et al., J. Phys. Chem. C, 2023 , 127, 7901-7912 . X. Chu, Y. Shi, L. Liu, Y. Huang and N. Li, J. Mater. Chem. A , 2019 , 7, 7717-7727. M. G. Marino and K. D. Kreuer, ChemSusChem , 2015 , 8, 513-523 Y. M. Lee, et al., Angew. Chem. Int. Ed. , 2021 , 60, 19272-19280. G. W. Coates, et al., J. Org. Chem. , 2021 , 86, 254-264. S. Doherty et. al., J. Membr. Sci, Manuscript currently under review. Figure 1