Comparing thixotropic and Herschel–Bulkley parameterizations for continuum models of avalanches and subaqueous debris flows
Open Access
- 22 January 2018
- journal article
- research article
- Published by Copernicus GmbH in Natural Hazards and Earth System Sciences
- Vol. 18 (1) , 303-319
Abstract
Avalanches and subaqueous debris flows are two cases of a wide range of natural hazards that have been previously modeled with non-Newtonian fluid mechanics approximating the interplay of forces associated with gravity flows of granular and solid–liquid mixtures. The complex behaviors of such flows at unsteady flow initiation (i.e., destruction of structural jamming) and flow stalling (restructuralization) imply that the representative viscosity–stress relationships should include hysteresis: there is no reason to expect the timescale of microstructure destruction is the same as the timescale of restructuralization. The non-Newtonian Herschel–Bulkley relationship that has been previously used in such models implies complete reversibility of the stress–strain relationship and thus cannot correctly represent unsteady phases. In contrast, a thixotropic non-Newtonian model allows representation of initial structural jamming and aging effects that provide hysteresis in the stress–strain relationship. In this study, a thixotropic model and a Herschel–Bulkley model are compared to each other and to prior laboratory experiments that are representative of an avalanche and a subaqueous debris flow. A numerical solver using a multi-material level-set method is applied to track multiple interfaces simultaneously in the simulations. The numerical results are validated with analytical solutions and available experimental data using parameters selected based on the experimental setup and without post hoc calibration. The thixotropic (time-dependent) fluid model shows reasonable agreement with all the experimental data. For most of the experimental conditions, the Herschel–Bulkley (time-independent) model results were similar to the thixotropic model, a critical exception being conditions with a high yield stress where the Herschel–Bulkley model did not initiate flow. These results indicate that the thixotropic relationship is promising for modeling unsteady phases of debris flows and avalanches, but there is a need for better understanding of the correct material parameters and parameters for the initial structural jamming and characteristic time of aging, which requires more detailed experimental data than presently available.Keywords
All Related Versions
This publication has 61 references indexed in Scilit:
- Some experiences with the numerical simulation of Newtonian and Bingham fluids in dip coatingComputers & Fluids, 2013
- Application of simulation technique on debris flow hazard zone delineation: a case study in the Daniao tribe, Eastern TaiwanNatural Hazards and Earth System Sciences, 2011
- The dam-break problem for Herschel–Bulkley viscoplastic fluids down steep flumesJournal of Non-Newtonian Fluid Mechanics, 2009
- Plasticity and geophysical flows: A reviewJournal of Non-Newtonian Fluid Mechanics, 2007
- Viscoplastic flow over an inclined surfaceJournal of Non-Newtonian Fluid Mechanics, 2007
- Transient phenomena in vesicular lava flows based on laboratory experiments with analogue materialsJournal of Volcanology and Geothermal Research, 2004
- TVD schemes for unstructured gridsInternational Journal of Heat and Mass Transfer, 2003
- Flow of variably fluidized granular masses across three‐dimensional terrain: 1. Coulomb mixture theoryJournal of Geophysical Research, 2001
- Large debris flows: A macro-viscous phenomenonActa Mechanica, 1986
- An investigation of the laws of plastic flowBulletin of the Bureau of Standards, 1916