A numerical method based on pore‐pressure cohesive zone modeling for simulation of debulking in resin‐saturated composite prepregs
Authors:
- 15 March 2022
- journal article
- research article
- Published by Wiley in International Journal for Numerical Methods in Engineering
- Vol. 123 (12) , 2791-2813
Abstract
Aircraft composite parts are commonly manufactured from resin‐saturated thermoset pre‐impregnated plies laid‐up over a rigid tool and consolidated and cured in an autoclave. In many applications, autoclave consolidation alone is not sufficient to remove the air, or bulk, that has been entrapped within the laminate during layup. Entrapped bulk can lead to the formation of defects, including wrinkles and voids, which can significantly affect structural performance. Vacuum consolidation, or “debulking,” has been a standard practice extensively used by aircraft manufacturers to reduce the amount of bulk and mitigate defect formation. Yet, the underlying physical principles governing formation of defects during these early stages are not well understood. This work presents the development of a new finite element‐based method for simulation of debulking with the objective to contribute to a better understanding of the key physics involved. The model includes pore‐pressure cohesive elements inserted at ply interfaces for discrete representation of entrapped air pockets and modeling air flow during debulking; and cohesive contact between the plies for simulating the typical tacky behavior of uncured thermoset tape prepregs. The debulking of a two‐ply laminate with an initial seeded wrinkle is considered for illustration of the approach and comparison with experimental results.Keywords
Funding Information
- Office of Naval Research (N00014‐18‐1‐2120)
This publication has 22 references indexed in Scilit:
- Optimization of curing cycle in carbon fiber-reinforced laminates: Void distribution and mechanical propertiesComposites Science and Technology, 2013
- 3D damage characterisation and the role of voids in the fatigue of wind turbine blade materialsComposites Science and Technology, 2012
- Numerical modeling of hydraulic fracture problem in permeable medium using cohesive zone modelEngineering Fracture Mechanics, 2012
- Measurement and analysis on in-plane and through-thickness air permeation of fiber/resin prepregJournal of Reinforced Plastics and Composites, 2011
- Effect of curing cycle on void distribution and interlaminar shear strength in polymer-matrix compositesComposites Science and Technology, 2011
- Through thickness air permeability of prepregs during cureComposites Part A: Applied Science and Manufacturing, 2009
- Failure Predictions for Carbon/Epoxy Tape Laminates with Wavy PliesJournal of Composite Materials, 2009
- The effect of voids on the flexural fatigue performance of unidirectional carbon fibre composites developed for wind turbine applicationsInternational Journal of Fatigue, 2006
- Modeling and simulation of two-dimensional consolidation for thermoset matrix compositesComposites Part A: Applied Science and Manufacturing, 2002
- Effects of Layer Waviness on the Compression Strength of Thermoplastic Composite LaminatesJournal of Reinforced Plastics and Composites, 1993