Porosity and microstructure control of porous ceramics by partial hot pressing
Authors:
- 1 July 2001
- journal article
- Published by Springer Nature in Journal of Materials Research
- Vol. 16 (7) , 1916-1918
Abstract
Precise control of porosity and microstructure of porous ceramics is essential. This paper describes a method for the preparation of porous ceramics with porosity from 0.0 to 0.4. The ceramics were prepared via hot pressing a powder mixture to a definite dimension, and the porosity was easily adjusted by the powder amount. As examples, porous Si3N4 or SiC ceramics were produced by powder mixtures that contained Si3N4 or SiC and a sintering additive of oxide. It was demonstrated that the present method is advantageous for producing ceramics with controllable porosity and microstructure.Keywords
This publication has 9 references indexed in Scilit:
- High-strength porous silicon nitride fabricated by the sinter-forging techniqueJournal of Materials Research, 2001
- Fracture Energy of an Aligned Porous Silicon NitrideJournal of the American Ceramic Society, 2000
- Engineered Porosity via Tape Casting, Lamination and the Percolation of Pyrolyzable ParticulatesJournal of the American Ceramic Society, 1999
- Porous Materials1998
- Strain Tolerant Porous Silicon NitrideJournal of the American Ceramic Society, 1997
- Mechanical properties of a partially sintered aluminaJournal of the European Ceramic Society, 1995
- Mechanical Properties of Partially Dense Alumina Produced from Powder CompactsJournal of the American Ceramic Society, 1994
- Mechanical properties and microstructures of machinable silicon carbideJournal of Materials Science, 1993
- Densification during Sintering in the Presence of a Liquid Phase. I. TheoryJournal of Applied Physics, 1959