The geometry, mechanics of formation, and plasticity conditions for the “continuous” type of chip have been analyzed in detail as a result of previous research. The present paper formulates a similar analysis of the “discontinuous” type of chip. In this type of chip formation, segments are formed by rupture which occurs intermittently on the shear plane as the cutting tool progresses. As the tool advances into the cut immediately following rupture of a segment, the metal is first deformed plastically and the angle of shear is large. Rupture is prevented during this stage by the fact that the compressive stress on the shear plane is high enough to permit the metal to undergo considerable shearing strain without fracture. As the tool progresses, the shear angle falls until the compressive stress becomes sufficiently low (or the shearing strain becomes sufficiently high) to permit fracture. The cycle then repeats.