Mechanical Properties and Metal-Ceramic Bond Strength of Co-Cr Alloy Manufactured by Selective Laser Melting
Open Access
- 16 December 2020
- Vol. 13 (24) , 5745
Abstract
Cobalt–chromium (Co-Cr) metal is one of the widely used biomaterials in the fabrication of dental prosthesis. The purpose of this study was to investigate whether there are differences in the properties of metals and bond strength with ceramics depending on the manufacturing methods of Co-Cr alloy. Co-Cr alloy specimens were prepared in three different ways: casting, milling, and selective laser melting (SLM). The mechanical properties (elastic modulus, yield strength, and flexural strength) of the alloys were investigated by flexure method in three-point bending mode, and microstructures of the specimens were analyzed. After application of the veneering ceramic through the three-point bending test, bond strength of the Metal-Ceramic was investigated. The cracked surfaces were observed by means of energy dispersive X-ray (EDX) spectroscopy and scanning electron microscopy (SEM) with backscattered electron (BSE) images. In mechanical properties, the elastic modulus was highest for the casting group, and the yield strength and flexural strength were lowest for the milling group. The SLM group showed finer homogeneous crystalline-microstructure, and a layered structure was observed at the fractured surface. After the ceramic bond strength test, all groups showed a mixed failure pattern. The casting group showed the highest bond strengths, whereas there was no significant difference between the other two groups. However, all groups have met the standard of bond strength according to international standards organization (ISO) with the appropriate passing rate. The results of this study indicate that the SLM manufacturing method may have the potential to replace traditional techniques for fabricating dental prosthesis.Keywords
Funding Information
- National Research Foundation of Korea (NRF-2018R1D1A1B07042333)
This publication has 45 references indexed in Scilit:
- Evaluation of the mechanical properties and porcelain bond strength of cobalt-chromium dental alloy fabricated by selective laser meltingThe Journal of Prosthetic Dentistry, 2014
- Metal–ceramic bond strength of Co–Cr alloy fabricated by selective laser meltingJournal of Dentistry, 2012
- Corrosion characteristics of a selective laser melted Co–Cr dental alloy under physiological conditionsJournal of Materials Science, 2012
- Modelling of energy attenuation due to powder flow-laser beam interaction during laser cladding processJournal of Materials Processing Technology, 2012
- The future of dental devices is digitalDental Materials, 2012
- Effect of different air-abrasion particles on metal-ceramic bond strengthJournal of Dental Sciences, 2011
- The Use of CAD/CAM in DentistryDental Clinics of North America, 2011
- Metal‐Ceramic Alloys in Dentistry: A ReviewJournal of Prosthodontics, 2009
- High density selective laser melting of Waspaloy®Journal of Materials Processing Technology, 2008
- Effect of Heat Treatment on Microstructure and Mechanical Properties of Ni- and C-Free Co–Cr–Mo Alloys for Medical ApplicationsMATERIALS TRANSACTIONS, 2005