Graphene oxide/SnO2 Nanocomposite as Sensing Material for Breathalyzers: Selective Detection of Ethanol in the presence of Automotive CO and Hydrocarbons Emissions
Authors:
- Maedeh ArvaniMAMaedeh Arvani
- Hamide Mohammad AlihaHAHamide Mohammad Aliha
- Abbas Ali KhodadadiAKAbbas Ali Khodadadi
- Yadollah MortazaviYMYadollah Mortazavi
Open Access
- 30 August 2017
- journal article
- Published by SCI AND TECH UNIVERSAL INC in Scientia Iranica
Abstract
SnO2 was ultrasonically deposited-precipitated in the presence of different amounts of graphene oxide (GO) prepared by the modified Hummers’ method. The resulting nanocomposites were used as the sensing material for detection of 1000 ppm CO and VOCs including ethanol, acetone and toluene and CH4 in a temperature range of 150-300°C. The nanocomposites were characterized by Raman spectroscopy, XRD, BET surface area measurement, FT-IR and SEM methods. It seems that SnO2 layers were deposited on the GO surface and incorporated into the matrix. This results in 47% increase in the nanocomposite BET surface area. Addition of 0.1 wt% GO to SnO2 increases the response to CO by about 6 times, at 300°C. As an optimum amount of 0.05 wt% GO is included in the SnO2, up to 2 fold enhancement in response to ethanol and toluene is observed. At 250oC, the highest response to ethanol is obtained, which is 120, 114, 1400 and 15 times larger than the responses to CO, toluene, methane and acetone, respectively, making the sensors quite selective to ethanol. Furthermore, this sensor exhibited good response in the low concentration of ethanol.Keywords
This publication has 24 references indexed in Scilit:
- Reduced graphene oxide encapsulated sulfur spheres for the lithium-sulfur battery cathodeResults in Physics, 2017
- Graphene/biofilm composites for enhancement of hexavalent chromium reduction and electricity production in a biocathode microbial fuel cellJournal of Hazardous Materials, 2016
- An ultra clean self-aligned process for high maximum oscillation frequency graphene transistorsCarbon, 2014
- Highly sensitive and selective sensors to volatile organic compounds using MWCNTs/SnO2Sensors and Actuators B: Chemical, 2012
- Flower-like SnO2/graphene composite for high-capacity lithium storageApplied Surface Science, 2012
- High sensitivity and fast response SnO2 and La-SnO2 catalytic pellet sensors in detecting volatile organic compoundsProcess Safety and Environmental Protection, 2011
- Analysis of industrial contaminants in indoor air: Part 1. Volatile organic compounds, carbonyl compounds, polycyclic aromatic hydrocarbons and polychlorinated biphenylsJournal of Chromatography A, 2009
- An enrichment method to detect low concentration formaldehydeSensors and Actuators B: Chemical, 2008
- Highly sensitive thin film NH3 gas sensor operating at room temperature based on SnO2/MWCNTs compositeSensors and Actuators B: Chemical, 2008
- Preparation of Fischer–Tropsch cobalt catalysts supported on carbon nanofibers and silica using homogeneous deposition-precipitationJournal of Catalysis, 2006