Influence of silicon on the microstructures, mechanical properties and stretch-flangeability of dual phase steels
Authors:
Open Access
- 5 August 2014
- journal article
- research article
- Published by Springer Nature in International Journal of Minerals, Metallurgy and Materials
- Vol. 21 (8) , 755-765
Abstract
Uniaxial tension tests and hole-expansion tests were carried out to determine the influence of silicon on the microstructures, mechanical properties, and stretch-flangeability of conventional dual-phase steels. Compared to 0.03wt% silicon, the addition of 1.08wt% silicon induced the formation of finer ferrite grains (6.8 μm) and a higher carbon content of martensite (C m ≈ 0.32wt%). As the silicon level increased, the initial strain-hardening rate (n value) and the uniform elongation increased, whereas the yield strength, yield ratio, and stretch-flangeability decreased. The microstructures were observed after hole-expansion tests. The results showed that low carbon content martensite (C m ≈ 0.19wt%) can easily deform in coordination with ferrite. The relationship between the mechanical properties and stretch-flangeability indicated that the steel with large post-uniform elongation has good stretch-flangeability due to a closer plastic incompatibility of the ferrite and martensite phases, which can effectively delay the production and decohesion of microvoids.Keywords
This publication has 40 references indexed in Scilit:
- Microstructures and mechanical properties of C-Mn-Cr-Nb and C-Mn-Si-Nb ultra-high strength dual-phase steelsInternational Journal of Minerals, Metallurgy and Materials, 2012
- Effect of micro-alloying elements on the stretch-flangeability of dual phase steelMaterials Science and Engineering: A, 2012
- Effect of grain refinement to 1μm on strength and toughness of dual-phase steelsMaterials Science and Engineering: A, 2010
- Hole-expansion formability of dual-phase steels using representative volume element approach with boundary-smoothing techniqueMaterials Science and Engineering: A, 2010
- Numerical simulation on the microstress and microstrain of low Si-Mn-Nb dual-phase steelInternational Journal of Minerals, Metallurgy and Materials, 2010
- Improvement of stretch flangeability of ultra high strength steel sheet by smoothing of sheared edgeJournal of Materials Processing Technology, 2010
- Influence of bainite/martensite-content on the tensile properties of low carbon dual-phase steelsMaterials Science and Engineering: A, 2008
- Estimation of hole flangeability for high strength steel platesJournal of Materials Processing Technology, 2002
- Effect of morphology of second-phase martensite on tensile properties of Fe-0.1C dual phase steelsJournal of Materials Science, 1990
- Void formation during tensile testing of dual phase steelsMetallurgical Transactions A, 1988