Novel 3D printed synthetic dielectric substrates
Open Access
- 29 July 2015
- journal article
- research article
- Published by Wiley in Microwave and Optical Technology Letters
- Vol. 57 (10) , 2344-2346
Abstract
This letter presents dielectric properties of air filled synthetic substrates fabricated in a single process using three‐dimensional printing. The permittivity and loss tangent of a given sized substrate can be changed by controlling the air infill volume fraction. © 2015 Wiley Periodicals, Inc. Microwave Opt Technol Lett 57:2344–2346, 2015Keywords
Funding Information
- Engineering and Physical Sciences Research Council (EP/I01490X/1)
This publication has 9 references indexed in Scilit:
- 3D printed plastic 60 GHz lens: Enabling innovative millimeter wave antenna solution and system2014
- Additively manufactured heterogeneous substrates for three‐dimensional control of local permittivityElectronics Letters, 2014
- 3D printed miniaturized UWB antenna for wireless body area network2014
- 3D Printing for the Rapid Prototyping of Structural ElectronicsIEEE Access, 2014
- Bone tissue engineering using 3D printingMaterials Today, 2013
- A New Low Loss Rotman Lens Design Using a Graded Dielectric SubstrateIEEE Transactions on Microwave Theory and Techniques, 2008
- Multilayer and conformal antennas using synthetic dielectric substratesIEEE Transactions on Antennas and Propagation, 2003
- Hawk-ShadowAppalachian Review, 1996
- Measurements of the complex permittivity of microwave circuit board substrates using split dielectric resonator and reentrant cavity techniques1996