Modelling the Shear-Tension Coupling of Woven Engineering Fabrics
Authors:
Open Access
- 24 March 2013
- journal article
- research article
- Published by Wiley in Advances in Materials Science and Engineering
- Vol. 2013, 1-9
Abstract
An approach to incorporate the coupling between the shear compliance and in-plane tension of woven engineering fabrics, in finite-element-based numerical simulations, is described. The method involves the use of multiple input curves that are selectively fed into a hypoelastic constitutive model that has been developed previously for engineering fabrics. The selection process is controlled by the current value of the in-plane strain along the two fibre directions using a simple algorithm. Model parameters are determined from actual experimental data, measured using the Biaxial Bias Extension test. An iterative process involving finite element simulations of the experimental test is used to normalise the test data for use in the code. Finally, the effectiveness of the method is evaluated and shown to provide qualitatively good predictions.Keywords
Funding Information
- Royal Academy of Engineering (10177/181, R11-2005-065)
- National Research Foundation of Korea (10177/181, R11-2005-065)
This publication has 27 references indexed in Scilit:
- Characterising the shear–tension coupling and wrinkling behaviour of woven engineering fabricsComposites Part A: Applied Science and Manufacturing, 2012
- Rate dependent modelling of the forming behaviour of viscous textile compositesComposites Part A: Applied Science and Manufacturing, 2011
- Simulation of wrinkling during textile composite reinforcement forming. Influence of tensile, in-plane shear and bending stiffnessesComposites Science and Technology, 2011
- Numerical study on thermo-stamping of woven fabric composites based on double-dome stretch formingInternational Journal of Material Forming, 2009
- Non-orthogonal constitutive model for woven composites incorporating tensile effect on shear behaviorInternational Journal of Material Forming, 2008
- Predictive modelling for optimization of textile composite formingComposites Science and Technology, 2007
- Finite element forming simulation for non-crimp fabrics using a non-orthogonal constitutive equationComposites Part A: Applied Science and Manufacturing, 2005
- Characterisation of material properties for draping of dry woven composite materialComposites Part A: Applied Science and Manufacturing, 2003
- Mechanical and numerical modelling of composite manufacturing processes deep-drawing and laying-up of thin pre-impregnated woven fabricsJournal of Materials Processing Technology, 2001
- Stamp forming of continuous glass fibre reinforced polypropyleneComposites Part A: Applied Science and Manufacturing, 1997