Predictions of the Effects of High Temperature Walls, Combustion, and Knock on Heat Transfer in Engine-Type Flows
Authors:
- Jialin YangJYJialin Yang
- 1 February 1990
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
Consideration of the heat transfer effects in low-heat-rejection engines has prompted further study into engine heat transfer phenomena. In a previous study, an approximate solution of the one-dimensional energy equation was acquired for transient, compressible, low-Mach number, turbulent boundary layers typical of those found in engines. The current study shows that an approximate solution of the one-dimensional energy equation with arbitrarily-distributed heat release can also be obtained. Using this model, the effects of high temperature walls, combustion, and autoignition on heat transfer can be studied. In the case of high temperature walls, the model predicts the expected behavior unless the quench distance gets very small. For combustion, the reaction must occur close to the wall for a direct effect on the heat transfer to be observed. With autoignition, instantaneous values of heat flux reach levels as high as 6 MW/m2, and oscillate in phase with the pressure wave. Finally, a method for using this model for global heat transfer predictions is suggested.Keywords
This publication has 11 references indexed in Scilit:
- Approximate Solution—One-Dimensional Energy Equation for Transient, Compressible, Low Mach Number Turbulent Boundary Layer FlowsJournal of Heat Transfer, 1989
- Effect of Knock on Time-Resolved Engine Heat TransferSAE International Journal of Advances and Current Practices in Mobility, 1989
- Heat Transfer Predictions and Experiments in a Motored EngineSAE International Journal of Advances and Current Practices in Mobility, 1988
- Heat Insulation of Combustion Chamber Walls — A Measure to Decrease the Fuel Consumption of I.C. Engines?SAE International Journal of Advances and Current Practices in Mobility, 1987
- Internal-combustion engine heat transferProgress in Energy and Combustion Science, 1987
- A Model for Predicting Spatially and Time Resolved Convective Heat Transfer in Bowl-in-Piston Combustion ChambersSAE International Journal of Advances and Current Practices in Mobility, 1985
- Computer Analysis of Fuel-Air Mixing and Combustion in an Axisymmetric D.I DieselSAE International Journal of Advances and Current Practices in Mobility, 1982
- A Universally Applicable Equation for the Instantaneous Heat Transfer Coefficient in the Internal Combustion EngineSAE International Journal of Advances and Current Practices in Mobility, 1967
- Flame quenching at the walls of an internal combustion engineSymposium (International) on Combustion, 1957
- The Wall-Quenching of Laminar Propane Flames as a Function of Pressure, Temperature, and Air-Fuel RatioJournal of Applied Physics, 1950