Automated body weight measurement using computed tomography
Open Access
- 15 October 2025
- journal article
- research article
- Published by Springer Nature in Scientific Reports
- Vol. 15 (1) , 1-11
Abstract
Computed tomography (CT) images provide detailed information on tissue composition and density. Body weight estimation from CT can be highly relevant in emergency and forensic contexts where conventional weighing is impractical or unavailable—for example, due to unconscious or immobilized patients, lack of appropriate equipment, or the necessity to preserve forensic trace evidence. An automated method for body weight estimation using antemortem and postmortem CT data from clinical scanners was evaluated. Two retrospective cohorts were included: 30 forensic postmortem whole-body CT scans and 66 clinical torso CT scans. Tissue segmentation applied predefined Hounsfield Unit thresholds for fat, muscle, and bone, with voxel volumes multiplied by corresponding tissue densities to calculate weight. In forensic cases, CT-derived weights differed by − 1.26 ± 2.58 kg (median: − 1.15 kg) from measured weights. In clinical cases, torso weight was extrapolated to total body weight using a corrected scaling factor that accounted for body and scan length, resulting in an average difference of 0.53 ± 4.62 kg (median: 0.23 kg). Linear regression demonstrated strong correlations (R2 = 0.97/0.96 forensic/clinical). These findings indicate that routinely acquired CT scans enable accurate, automated, and retrospective body weight estimation, providing a non-invasive alternative when direct measurement is not feasible while simultaneously allowing body composition analysis.Keywords
Funding Information
- Universitätsklinikum Jena
This publication has 36 references indexed in Scilit:
- A practical and precise approach to quantification of body composition in cancer patients using computed tomography images acquired during routine careApplied Physiology, Nutrition, and Metabolism, 2008
- Estimation of time since death by heat-flow Finite-Element model. Part I: method, model, calibration and validationLegal Medicine, 2005
- Estimation of the time since death in the early post-mortem periodForensic Science International, 2004
- A new device for measuring density of jaw bones.Dentomaxillofacial Radiology, 2002
- Cadaver validation of skeletal muscle measurement by magnetic resonance imaging and computerized tomographyJournal of Applied Physiology, 1998
- Segmental inertial parameters of the human trunk as determined from computed tomographyAnnals of Biomedical Engineering, 1996
- Changes in body composition and adipose tissue distribution after treatment of women with Cushing's syndromeMetabolism, 1994
- Adipose tissue density, estimated adipose lipid fraction and whole body adiposity in male cadavers.1994
- Investigation into the mass distribution properties of the human body and its segmentsErgonomics, 1984
- Density of fresh and embalmed human compact and cancellous boneAmerican Journal of Physical Anthropology, 1968