Facile Strategy for Third Component Optimization in Wide-Band-Gap π-Conjugated Polymer Donor-Based Efficient Ternary All-Polymer Solar Cells
- 28 February 2022
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 14 (9) , 11211-11221
Abstract
Emerging organic solar cells based on a ternary strategy is one of the most effective methods for improving the blend film morphology, absorption ability, and device performances. On the other hand, this strategy has had very limited success in all-polymer solar cells (all-PSCs) because of the scarcity of new polymers and the challenges faced during third component optimization. Herein, highly efficient ternary all-PSCs were developed from siloxane-functionalized side chains with a wide-band-gap (Eg) polymer, Si-BDT, which is blended with a medium and ultra-narrow Eg polymer donor and acceptor, PTB7-Th, and DCNBT-TPIC. An impressive power conversion efficiency (PCE) of 13.45% was achieved in the ternary all-PSCs [PTB7-Th(0.6):Si-BDT(0.4):DCNBT-TPIC(0.6)] with the addition of 0.4 wt equivalent Si-BDT into binary all-PSCs [PTB7-Th(1):DCNBT-TPIC(0.6) PCE of 10.11%]. In contrast, the binary all-PSCs with a Si-BDT(1):DCNBT-TPIC(0.6) active layer only exhibited a good PCE of 9.92%. More importantly, the siloxane-functionalized side chains increase the light-absorption ability, carrier mobility, blend miscibility, and film morphology in ternary devices compared to those of the binary devices. Hence, exciton dissociation, charge carrier transport, and suppressed recombination properties were facilitated. In the presence of Si-BDT, both binary and ternary all-PSCs PCEs are significantly improved. Indeed, 13.45% PCE is one of the best values reported for all-PSCs except for those based on polymerized small molecule acceptors. In addition, the ternary all-PSCs showed excellent environmental and thermal stabilities with 95 and 84% of the initial PCE retained after 900 and 500 h, respectively. These results offer effective device engineering, providing a new avenue for improving the device performance in ternary all-PSCs.Keywords
Funding Information
- National Research Foundation of Korea (NRF-2018R1A5A1025594)
- Science, Technology and Innovation Commission of Shenzhen Municipality (JCYJ20190809162003662)
- National Natural Science Foundation of China (22005135)
This publication has 57 references indexed in Scilit:
- 9.0% power conversion efficiency from ternary all-polymer solar cellsEnergy & Environmental Science, 2017
- Low band gap conjugated polymers combining siloxane-terminated side chains and alkyl side chains: side-chain engineering achieving a large active layer processing window for PCE > 10% in polymer solar cellsJournal of Materials Chemistry A, 2017
- The Impact of Sequential Fluorination of π‐Conjugated Polymers on Charge Generation in All‐Polymer Solar CellsAdvanced Functional Materials, 2017
- 11.4% Efficiency non-fullerene polymer solar cells with trialkylsilyl substituted 2D-conjugated polymer as donorNature Communications, 2016
- Side‐Chain Fluorination: An Effective Approach to Achieving High‐Performance All‐Polymer Solar Cells with Efficiency Exceeding 7%Advanced Materials, 2016
- High-performance ternary blend polymer solar cells involving both energy transfer and hole relay processesNature Communications, 2015
- Ternary blend polymer solar cells with enhanced power conversion efficiencyNature Photonics, 2014
- Improved Efficiency of Bulk Heterojunction Polymer Solar Cells by Doping Low-Bandgap Small MoleculesACS Applied Materials & Interfaces, 2014
- Near IR Sensitization of Organic Bulk Heterojunction Solar Cells: Towards Optimization of the Spectral Response of Organic Solar CellsAdvanced Functional Materials, 2010
- Contact angles and adhesive bondingInternational Journal of Adhesion and Adhesives, 1992