First Solar Cells on Exfoliated Silicon Foils Obtained at Room Temperature by the SLIM-Cut Technique Using an Epoxy Layer
- 23 June 2016
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Photovoltaics
- Vol. 6 (5) , 1115-1122
Abstract
In this paper, we report on the first solar cells fabricated on silicon foils employing the stress-induced liftoff methodcut technique and using an epoxy stress-inducing layer. The latter is a 900-μm-thick epoxy layer, which was manually dispensed on the surface of a monocrystalline silicon sample and cured at 150 °C for 1 h. The crack propagation is then activated by cooling down the sample to room temperature on an aluminum plate. The structural and electrical properties of the resulting silicon foils are presented. The thickness of the silicon foil and the maximum roughness height after this process are found to be around 130 and 37.4 μm, respectively. Tensile and compressive regions present in the foil were detected by the birefringence technique and indicate the formation of structural defects such as dislocations during the process. Average minority carrier lifetimes around 28 μs were measured on n-type silicon foils after surface passivation by an iodine-ethanol solution. Photon conversion efficiencies of 12.6% and 13.4% are measured using conventional sun simulator (1-sun AM1.5G) and SINTON Suns-Voc setup systems, respectively.Keywords
Funding Information
- European Union Seventh Framework Program (608593)
This publication has 26 references indexed in Scilit:
- New Stress Activation Method for Kerfless Silicon Wafering Using Ag/Al and Epoxy Stress-Inducing LayersIEEE Journal of Photovoltaics, 2014
- Influence of Implantation Damage on Emitter RecombinationEnergy Procedia, 2014
- Solar Cell Processing of Foil Produced by Epoxy-induced Spalling of SiliconEnergy Procedia, 2014
- Development of a-Si:H/c-Si heterojunctions for the i2-module concept: Low-temperature passivation and emitter formation on wafers bonded to glassSolar Energy Materials and Solar Cells, 2013
- Defects in Si foils fabricated by spalling at low temperature: electrical activity and atomic natureJournal of Physics D: Applied Physics, 2013
- Analysis of stress intensity factors and T-stress to control crack propagation for kerf-less spalling of single crystal silicon foilsComputational Materials Science, 2013
- Kerfless Wafering for Silicon Wafers by Using a Reusable Metal LayerEnergy Procedia, 2013
- Kerf-Less Removal of Si, Ge, and III–V Layers by Controlled Spalling to Enable Low-Cost PV TechnologiesIEEE Journal of Photovoltaics, 2012
- Stress-induced large-area lift-off of crystalline Si filmsApplied Physics A, 2007
- Mixed Mode Cracking in Layered Materials1991