Texture development during cold rolling of Fe–Cr–Ni alloy-experiments and simulations
- 5 May 2017
- journal article
- research article
- Published by Taylor & Francis in Philosophical Magazine
- Vol. 97 (23) , 1939-1962
Abstract
Abstract In the present work, evolution of microstructure and crystallographic texture during cold rolling of two phase Fe–Cr–Ni alloy was investigated. Fe–Cr–Ni alloy (in initially solution annealed condition) was uni-directionally cold rolled in a laboratory rolling mill to different thickness reductions. Scanning electron microscopy was used to observe the changes in microstructure, while X-ray diffraction was used to investigate changes in crystallographic texture of austenite and ferrite (through changes in orientation distribution function). Crystallographic texture was also simulated using different crystal plasticity models (Full constraint Taylor, relaxed constraint Taylor (lath and pancake) and co-deformation Visco Plastic Self Consistent (VPSC)). With the increase in plastic deformation, there were morphological as well as crystallographic changes in the microstructure. Strong α-fibre (RD//〈1 1 0〉) texture was developed in ferrite, while brass ({1 1 0}〈1 1 2〉) and Goss ({1 1 0}〈0 0 1〉) was dominant in austenite after 80% cold rolling. The formation of brass type texture after deformation has been attributed to the formation of shear bands and presence of strong crystallographic texture in the initial solution annealed material. Both Taylor as well as VPSC models could not capture the changes in texture with deformation accurately. For ferrite: γ-fibre (ND//〈1 1 1〉) and for austenite: Cu ({1 1 2}〈1 1 1〉) component was always present in the simulated textures. Possible reason for this could be the pining effect of interface boundaries and non-incorporation of non-crystallographic shear banding in the Taylor and VPSC models.Keywords
Funding Information
- Science and Engineering Research Board (SERB), India (SB/FTP/ETA-0188/2014)
This publication has 61 references indexed in Scilit:
- Non-crystallographic shear banding in crystal plasticity FEM simulations: Example of texture evolution in α-brassActa Materialia, 2012
- Design of a novel Mn-based 1GPa duplex stainless TRIP steel with 60% ductility by a reduction of austenite stabilityActa Materialia, 2011
- Controlled Warm Working: Possible Tool for Optimizing Stored Energy Advantage in Deformed γ-fiber (ND//‹111›)ISIJ International, 2009
- Microstructural and crystallographic aspects of conventional and asymmetric rolling processesActa Materialia, 2008
- Micromechanical behavior and texture evolution of duplex stainless steel studied by neutron diffraction and self-consistent modelingActa Materialia, 2008
- Recrystallization Behavior and Texture Formation of Rapidly Annealed Cold-Rolled Extralow Carbon Steel SheetsMATERIALS TRANSACTIONS, 2006
- Deformation and Annealing Behavior of Nitrogen Alloyed Duplex Stainless Steels. Part I: RollingISIJ International, 2003
- Simulation of rolling textures of b.c.c. metals considering grain interactions and crystallographic slip on {110}, {112} and {123} planesMaterials Science and Engineering: A, 1995
- Texture simulation for hot rolling of aluminium by use of a Taylor model considering grain interactionsActa Metallurgica et Materialia, 1995
- A self-consistent anisotropic approach for the simulation of plastic deformation and texture development of polycrystals: Application to zirconium alloysActa Metallurgica et Materialia, 1993