Measurements of Surface Tension for Mineral and Crude Oil Systems
Authors:
- 1 February 2019
- journal article
- Published by Trans Tech Publications, Ltd. in Defect and Diffusion Forum
- Vol. 391, 106-113
Abstract
For the most part, Surface tension is relying upon the force adjusted on a drop that is pending or hanging and inevitably is disengaged. Surfaces of fluids normally covered with what goes about as a tiny film. In spite of the fact that this evident film has little quality, it nevertheless acts like a thin membrane and resists being broken. This accepted to be the reason for the attractive forces between the atoms inside a given framework. All atoms are pulled in one to the next in extent to the result of their masses and conversely as the squares of the separation between them. Surface tension for both mineral and oil crude systems is investigated and the value was recorded. In addition, this value for mineral oil system showed higher value than foamy crude oil system, whereas foamy oil saturated methane crude oil system showed lower value than foamy oil saturated methane mineral oil. Surface tension in its general form is believed to have a significant feature in reservoir engineering calculations as well as in further studies related to improved oil production and in designing enhanced oil recovery plans. Moreover, CH4, C2H6 and CO2 oil systems investigated for the initial production, drawdown experiments. After the investigation, the behaviour is identical for almost one-day and two-days.Keywords
This publication has 19 references indexed in Scilit:
- A Potential Parameter for A Non-Darcy Form of Two-Phase Flow Behaviour, Compressibility RelatedInternational Journal of Engineering & Technology, 2018
- Influence of fluid and operating parameters on the recovery factors and gas oil ratio in high viscous reservoirs under foamy solution gas driveFuel, 2017
- Studies on the Stability of the Foamy Oil in Developing Heavy Oil ReservoirsDefect and Diffusion Forum, 2017
- Influence of Compressibility on Heavy/FoamyOil FlowIOSR Journal of Engineering, 2017
- Evaluating and Estimating the Complex Dynamic Phenomena in Nonlinear Chemical SystemsInternational Journal of Chemical Reactor Engineering, 2011
- Mathematical and kinetic modeling of biofilm reactor based on ant colony optimizationProcess Biochemistry, 2010
- Foamy Oil Flow and its Role in Heavy Oil ProductionAIP Conference Proceedings, 2010
- SOFT SENSOR BASED NONLINEAR CONTROL OF A CHAOTIC REACTORIFAC Proceedings Volumes, 2009
- Measurement of Interfacial Tension for the CO2 Injected Crude Oil + Reservoir Water SystemJournal of Chemical & Engineering Data, 2005
- Surface Tension of Reservoir Crude-Oil/Gas Systems Recognizing the Asphalt in the Heavy FractionSPE Reservoir Engineering, 1988