Fracture of ultrafine calcium carbonate/polypropylene composites
Authors:
- 1 February 1989
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 10 (1) , 39-43
Abstract
The strength and fracture properties of a polypropylene filled with ultrafine calcium carbonate (0.07 μm) have been studied in the composition range of 0 to 40 percent by volume. Untreated and surface treated (with stearic acid and a titanate coupling agent) grades have been considered. The untreated filler caused a decrease of toughness whereas a maximum, at ∼10 percent, was observed for the treated filler. The fracture energy was analyzed in terms of the crack pinning model. Due to the very small size of particles the pinning contribution proved to be negligible.Keywords
This publication has 18 references indexed in Scilit:
- Strength versus composition of rigid matrix particulate compositesPolymer, 1986
- The elastic moduli of particulate-filled polymersJournal of Applied Polymer Science, 1984
- Microstructural aspects of failure in semicrystalline polymersPolymer Engineering & Science, 1984
- Crack propagation in a glass particle-filled epoxy resinJournal of Materials Science, 1984
- Studies of the effect of titanate coupling agent on the performance of polypropylene–calcium carbonate compositeJournal of Applied Polymer Science, 1982
- The effect of spherulite size on the fracture morphology of polypropyleneJournal of Materials Science, 1974
- The effect of interfacial bonding on the toughness of glass filled polymersMaterials Science and Engineering, 1971
- Elastic properties of filled and porous epoxy compositesInternational Journal of Mechanical Sciences, 1967
- Filler particle size and mechanical properties of polymersJournal of Applied Polymer Science, 1965
- The Elastic and Thermo-elastic Properties of Composite MediaProceedings of the Physical Society. Section B, 1956