The Use of a Movable Vehicle in a Stationary Condition for Indirect Bridge Damage Detection Using Baseline-Free Methodology
Open Access
- 16 November 2022
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 12 (22) , 11625
Abstract
The use of an instrumented scanning vehicle has become the center of focus for bridge health monitoring (BHM) due to its cost efficiency, mobility, and practicality. However, indirect BHM still faces challenges such as the effects of road roughness on vehicle response, which can be avoided when the vehicle is in a stationary condition. This paper proposes a baseline-free method to detect bridge damage using a stationary vehicle. The proposed method is implemented in three steps. First, the contact-point response (CPR) of the stationary vehicle is computed. Secondly, the CPR is decomposed into intrinsic mode functions (IMFs) using the variational mode decomposition (VMD) method. Finally, instantaneous amplitude (IA) of a high frequency IMF is computed. The peak represents the existence and location of the damage. A finite element model of a bridge with damage is created. The results show that the method can identify the damage location under different circumstances, such as a vehicle with and without damping, different speeds of the moving vehicle, different sizes of damage, and multiple damage. A higher speed was found to provide better visibility of damages. In addition, smaller damage was less visible than wider damage.Keywords
Funding Information
- Universiti Teknologi PETRONAS Malaysia (YUTP 015LC0-177)
This publication has 42 references indexed in Scilit:
- Using two connected vehicles to measure the frequencies of bridges with rough surface: a theoretical studyActa Mechanica, 2012
- Damage detection in structures under traveling loads by Hilbert–Huang transformMechanical Systems and Signal Processing, 2012
- Estimating Bridge Fundamental Frequency from Vibration Response of Instrumented Passing Vehicle: Analytical and Experimental StudyAdvances in Structural Engineering, 2012
- Extraction of bridge frequencies from the dynamic response of a passing vehicle enhanced by the EMD techniqueJournal of Sound and Vibration, 2009
- The use of vehicle acceleration measurements to estimate road roughnessVehicle System Dynamics, 2008
- A damage index for structural health monitoring based on the empirical mode decompositionJournal of Mechanics of Materials and Structures, 2007
- Wavelet Transform for Structural Health Monitoring: A Compendium of Uses and FeaturesStructural Health Monitoring, 2006
- Vibration Based Condition Monitoring: A ReviewStructural Health Monitoring, 2004
- Extracting bridge frequencies from the dynamic response of a passing vehicleJournal of Sound and Vibration, 2004
- The empirical mode decomposition and the Hilbert spectrum for nonlinear and non-stationary time series analysisProceedings of the Royal Society A: Mathematical, Physical and Engineering Sciences, 1998