Design of the first fusion experiment to achieve target energy gain
Top Cited Papers
- 5 February 2024
- journal article
- research article
- Published by American Physical Society (APS) in Physical Review E
- Vol. 109 (2) , 025204
Abstract
In this work we present the design of the first controlled fusion laboratory experiment to reach target gain N221204 (5 December 2022) [ Phys. Rev. Lett. 132, 065102 (2024)], performed at the National Ignition Facility, where the fusion energy produced (3.15 MJ) exceeded the amount of laser energy required to drive the target (2.05 MJ). Following the demonstration of ignition according to the Lawson criterion N210808, experiments were impacted by nonideal experimental fielding conditions, such as increased (known) target defects that seeded hydrodynamic instabilities or unintentional low-mode asymmetries from nonuniformities in the target or laser delivery, which led to reduced fusion yields less than 1 MJ. This Letter details design changes, including using an extended higher-energy laser pulse to drive a thicker high-density carbon (also known as diamond) capsule, that led to increased fusion energy output compared to N210808 as well as improved robustness for achieving high fusion energies (greater than 1 MJ) in the presence of significant low-mode asymmetries. For this design, the burnup fraction of the deuterium and tritium (DT) fuel was increased (approximately fuel burnup and a target gain of approximately 1.5 compared to approximately fuel burnup and target gain approximately 0.7 for N210808) as a result of increased total (DT plus capsule) areal density at maximum compression compared to N210808. Radiation-hydrodynamic simulations of this design predicted achieving target gain greater than 1 and also the magnitude of increase in fusion energy produced compared to N210808. The plasma conditions and hotspot power balance (fusion power produced vs input power and power losses) using these simulations are presented. Since the drafting of this manuscript, the results of this paper have been replicated and exceeded (N230729) in this design, together with a higher-quality diamond capsule, setting a new record of approximately of fusion energy and fusion energy target gain of approximately 1.9.
Keywords
Funding Information
- U.S. Department of Energy (DE-AC52-07NA27344)
This publication has 54 references indexed in Scilit:
- Multistep redirection by cross-beam power transfer of ultrahigh-power lasers in a plasmaNature Physics, 2012
- Point design targets, specifications, and requirements for the 2010 ignition campaign on the National Ignition FacilityPhysics of Plasmas, 2011
- Tuning the Implosion Symmetry of ICF Targets via Controlled Crossed-Beam Energy TransferPhysical Review Letters, 2009
- First-principles multiphase equation of state of carbon under extreme conditionsPhysical Review B, 2008
- Updated Opal OpacitiesThe Astrophysical Journal, 1996
- Review of the department of energy's inertial confinement fusion programJournal of Fusion Energy, 1991
- Laser-Driven Implosion of Spherical DT Targets to Thermonuclear Burn Conditions.Physical Review Letters, 1973
- Laser Compression of Matter to Super-High Densities: Thermonuclear (CTR) ApplicationsNature, 1972
- Some Criteria for a Power Producing Thermonuclear ReactorProceedings of the Physical Society. Section B, 1957
- Controlled Fusion Research—An Application of the Physics of High Temperature PlasmasReviews of Modern Physics, 1956