Effect of Surface Roughness on Heat Transfer and Fluid Flow Characteristics at Low Reynolds Numbers in Small Diameter Tubes
Authors:
- 1 May 2003
- journal article
- research article
- Published by Taylor & Francis in Heat Transfer Engineering
- Vol. 24 (3) , 4-16
Abstract
The effect of surface roughness on pressure drop and heat transfer in circular tubes has been extensively studied in literature. The pioneering work of Nikuradse [1] established the sand grain roughness as a major parameter in defining the friction factor during laminar and turbulent flows. Recent studies have indicated a transition to turbulent flows at Reynolds number values much below 2300 during single-phase flow in channels with small hydraulic diameters. In the present work, a detailed experimental study is undertaken to investigate the roughness effects in small diameter tubes. The roughness of the inside tube surface is changed by etching it with an acid solution. Two tubes of 1.032 mm and 0.62 mm inner diameter are treated with acid solutions to provide three different roughness values for each tube. The Reynolds number range for the tests is 500-2600 for 1.067 mm tube and 900-3000 for 0.62 mm tube.Keywords
This publication has 5 references indexed in Scilit:
- Developing convective heat transfer in deep rectangular microchannelsInternational Journal of Heat and Fluid Flow, 1999
- FRICTIONAL FLOW CHARACTERISTICS OF WATER FLOWING THROUGH RECTANGULAR MICROCHANNELSExperimental Heat Transfer, 1994
- Measurement of the heat transfer characteristics of gas flow in fine channel heat exchangers used for microminiature refrigeratorsCryogenics, 1984
- Measurement of friction factors for the flow of gases in very fine channels used for microminiature Joule-Thomson refrigeratorsCryogenics, 1983
- Gesetzmäßigkeiten der turbulenten Strömung in glatten Rohren (Nachtrag)Forschung im Ingenieurwesen, 1933