Modulation Asymmetry Suppression of Multifunction Integrated Optic Circuit by Sinking Electrode
Open Access
- 9 September 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 165529-165535
Abstract
The modulation asymmetry of a multifunction integrated optic circuit (MIOC) indicates the difference in the phase response to modulation electric fields with the same magnitude but different directions, and is partly caused by the vertical component of the modulation signal. This introduces a nonlinear phase error that is difficult to compensate in fiber optic gyroscopes (FOGs), which needs to be suppressed. In this paper, a sinking-electrode MIOC design to suppress the modulation asymmetry is proposed and verified through numerical simulations. Optimal parameters of the gap, height, side-wall angle, and center position error of the sinking electrodes are obtained on the basis of the simulation results. With the proposed method, the modulation asymmetry of MIOC can be reduced from 5×10-4 rad to 1×10-6 rad, thus facilitating the development of high-performance FOGs. Furthermore, compared with the traditional electrode design, the sinking-electrode design can increase the tolerance for the manufacturing process, and the design configuration can be obtained through the general process method.Keywords
Funding Information
- National Natural Science Foundation of China (61935002)
This publication has 27 references indexed in Scilit:
- Measurement and control of residual amplitude modulation in optical phase modulationReview of Scientific Instruments, 2012
- Analysis and Control of the DC Drift in LiNbO3Based Mach–Zehnder ModulatorsJournal of Lightwave Technology, 2011
- Fabrication of ridge waveguides in LiNbO 3 thin film crystal by proton-exchange accelerated etchingElectronics Letters, 2009
- Highly Efficient $+$5-dB Parametric Gain Conversion Using Direct-Bonded PPZnLN Ridge WaveguideIEEE Photonics Technology Letters, 2007
- Lithium niobate optical modulators: Devices and applicationsJournal of Crystal Growth, 2006
- Ridge structure etching of LiNbO3 crystal for optical waveguide applicationsOptical Materials, 2005
- Improved electrooptic modulator with ridge structure in X-cut LiNbO/sub 3/Journal of Lightwave Technology, 1999
- Extraordinary-mode refractive-index change produced by the linear electro-optic effect in LiNbO_3 and reverse-poled LiNbO_3Applied Optics, 1995
- Overlap integral factors in integrated optic modulators and switchesJournal of Lightwave Technology, 1989
- Optimal electrode design for integrated optics modulatorsIEEE Journal of Quantum Electronics, 1982