A New Approach for the Measurement of Film Thickness in Liquid Face Seals
- 25 March 2008
- journal article
- research article
- Published by Taylor & Francis in Tribology Transactions
- Vol. 51 (2) , 140-149
Abstract
Face seals operate by allowing a small volume of the sealed fluid to escape and form a thin film between the contacting parts. The thickness of this film must be optimized to ensure that the faces are separated, yet the leakage is minimized. In this work the liquid film is measured using a novel ultrasonic approach with a view to developing a condition monitoring tool. The trials were performed in two stages. Initially tests were based on a lab simulation, where it was possible to compare the ultrasonic film thickness measurements with optical interference methods and capacitance methods. A direct correlation was seen between ultrasonic measurements and capacitance. Where ultrasonic and optical methods overlap, good correlation is observed; however, the optical method will not record film thickness above ∼ 0.72 μ m. A second set of trials was carried out, where the film thickness was monitored inside a seal test apparatus. Film thickness was successfully recorded as speed and load were varied. The results showed that while stationary the film thickness varied noticeably with load. When rotating, however, the oil film remained relatively stable around 2 μ m. During the normal operation of the seal, both sudden speed and load changes were applied in order to initiate a seal failure. During these events, the measured film thickness was seen to drop dramatically down to 0.2 μ m. This demonstrated the ability of the technique to predict failure in a face seal and therefore its aptitude for condition monitoring.Keywords
This publication has 14 references indexed in Scilit:
- The Phase Shift of an Ultrasonic Pulse at an Oil Layer and Determination of Film ThicknessProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2005
- Operating Limits for Acoustic Measurement of Rolling Bearing Oil Film ThicknessTribology Transactions, 2004
- The measurement of lubricant–film thickness using ultrasoundProceedings of the Royal Society A: Mathematical, Physical and Engineering Sciences, 2003
- Loss of lubricant from oil-lubricated near-starved spherical roller bearingsProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 1997
- The ultrasonic pulse-echo technique as applied to adhesion testingJournal of Physics D: Applied Physics, 1973
- An utrasonic study of the area of contact between stationary and sliding surfacesProceedings of the Royal Society of London. A. Mathematical and Physical Sciences, 1971
- Measures to Counter Fatigue Failure in Railway AxlesProceedings of the Institution of Mechanical Engineers, 1967
- Flow of Electric Current Through Lubricated ContactsA S L E Transactions, 1967
- Theoretical and experimental studies of the oil film in lubricated point contactProceedings of the Royal Society of London. A. Mathematical and Physical Sciences, 1966
- Measurement of Oil-Film Thickness Between Disks by Electrical ConductivityJournal of Basic Engineering, 1960