Effect of pH of the Solution on the Deposition of Zinc Oxide Films by Spray Pyrolysis
Authors:
- 1 April 1993
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 76 (4) , 998-1002
Abstract
A spray pyrolysis method has been used to deposit ZnO films on polycrystalline alumina substrates. The precursor is dissolved in aqueous solutions with different pH values. Depending on the pH, the growth rate either is low (less than 0.2 μm·h ‐1 ) for pH ≤3.1 and pH ≥4.7 or has significant values (>1.5 μm·h ‐1 ) for 3.5 ≤ pH ≥ 4.3. These experimental data are discussed in terms of a model which describes the chemical nature and concentrations of the Zn precursors which are potential candidates for the film formation.Keywords
This publication has 19 references indexed in Scilit:
- Optical properties of spray deposited ZnO filmsSolid State Communications, 1991
- Textured ZnO Thin Films for Solar Cells Grown by Metalorganic Chemical Vapor DepositionJapanese Journal of Applied Physics, 1991
- Growth of zinc oxide films by a novel ultrasonic nebulization and pyrolysis methodMaterials Research Bulletin, 1989
- Growth kinetics of ZnO prepared by organometallic chemical vapor depositionJournal of Materials Research, 1988
- Preparation of thin films in the system γFe2O3- Fe3O4for recording media by spray pyrolysis of organometallic solutions using an ultrasonic pumpIEEE Transactions on Magnetics, 1986
- Properties of ZnO films deposited onto InP by spray pyrolysisThin Solid Films, 1986
- Properties of thin In2O3 and SnO2 films prepared by corona spray pyrolysis, and a discussion of the spray pyrolysis processThin Solid Films, 1984
- Metalorganic chemical vapor deposition of oriented ZnO films over large areasApplied Physics Letters, 1983
- Highly transparent and conducting indium-doped zinc oxide films by spray pyrolysisThin Solid Films, 1983
- Chemical Vapor Deposition at Low TemperaturesJournal of the Electrochemical Society, 1975