Structural-Based Power-Aware Assignment of Don't Cares for Peak Power Reduction during Scan Testing
- 1 October 2006
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 403-408
Abstract
Scan architectures, though widely used in modern designs for testing purpose, are expensive in power consumption. In this paper, we first discuss the issues of excessive peak power consumption during scan testing. We next show that taking care of high current levels during the test cycle (i.e. between launch and capture) is highly relevant so as to avoid noise phenomena such as IR-drop or Ground Bounce. Then, we propose a solution based on power-aware assignment of don't care bits in deterministic test patterns that considers structural information of the circuit under test. Experiments have been performed on ISCAS'89 and ITC'99 benchmark circuits with the proposed structural-based power-aware X-filling technique. These results show that the proposed technique provides the best tradeoff between peak power reduction and increase of test sequence lengthKeywords
This publication has 8 references indexed in Scilit:
- Minimizing power consumption in scan testing: pattern generation and DFT techniques2005
- A case study of ir-drop in structured at-speed testing2004
- Scan Architecture With Mutually Exclusive Scan Segment Activation for Shift- and Capture-Power ReductionIEEE Transactions on Computer-Aided Design of Integrated Circuits and Systems, 2004
- BIST-aided scan test - a new method for test cost reduction2003
- Controlling peak power during scan testing2003
- A gated clock scheme for low power scan testing of logic ICs or embedded cores2002
- An analysis of power reduction techniques in scan testing2002
- Survey of low-power testing of VLSI circuitsIEEE Design & Test of Computers, 2002