The Perforation Resistance of Aluminum-Based Thermoplastic FMLs
Authors:
Open Access
- 1 March 2021
- journal article
- research article
- Published by Springer Nature in Applied Composite Materials
- Vol. 28 (3) , 587-605
Abstract
The perforation resistance of fibre metal laminates (FMLs) made of an S-glass fibre reinforced poly-ether-ketone-ketone (GF/PEKK) composite and an aluminium alloy (2024-T3) is investigated. Initial attention is focused on assessing the effect of the processing temperature on the tensile strength of the aluminium alloy. Here, it has shown that the processing cycle results in a reduction of approximately 35% in both the tensile strength and yield strength of the aluminium alloy. A comparison of the quasi-static and dynamic perforation responses of the FMLs highlighted the rate-sensitivity of these laminates, with the perforation energy increasing as the loading rate varies from quasi-static to impact. After testing, the FML specimens were sectioned to highlight the prevailing failure modes. An examination of the cross-sections indicated that the impact energy of the projectile is absorbed through plastic deformation and tearing of the metal layers, delamination between the composite plies and metal layers as well as fibre fracture. Finite element models (FEM), using ABAQUS/Explicit, have been developed to predict the behaviour of the FMLs subjected to dynamic loading. The outputs of the FE models were then validated against the measured experimental force–displacement traces and the observed failure modes. The results of the FE models were in a good agreement with the experimental data, in terms of the initial stiffness, maximum force and maximum displacement, as well as the perforation mechanisms.Keywords
This publication has 36 references indexed in Scilit:
- About the impact behavior of woven-ply carbon fiber-reinforced thermoplastic- and thermosetting-composites: A comparative studyComposite Structures, 2013
- The engineering aspects of automated prepreg layup: History, present and futureComposites Part B: Engineering, 2012
- The low-velocity impact response of fiber-metal laminatesJournal of Reinforced Plastics and Composites, 2010
- Numerical modeling of the impact response of fiber–metal laminatesPolymer Composites, 2008
- Investigation of Scaling Effects in Fiber—Metal LaminatesJournal of Composite Materials, 2008
- Low-Velocity Impact Response Characterization of a Hybrid Titanium Composite LaminateJournal of Engineering Materials and Technology, 2006
- Performance of long fiber reinforced thermoplastics subjected to transverse intermediate velocity blunt object impactComposite Structures, 2005
- The Tensile and Fatigue Properties of Carbon Fiber-reinforced PEEK-Titanium Fiber-metal LaminatesJournal of Reinforced Plastics and Composites, 2004
- A comprehensive failure model for crashworthiness simulation of aluminium extrusionsInternational Journal of Crashworthiness, 2004
- The high velocity impact response of composite and FML-reinforced sandwich structuresComposites Science and Technology, 2004