A New Method for Weld Dilution Calculation through Chemical Composition Analysis
Open Access
Abstract
Aiming at existing methods unable to reveal the definition of dilution in welding accurately, such as the limited formula’s range of 0~1 mathematically, a new way which can be widely applied to various welds alloying either one or more compositions was proposed. Dilution values obtained using different methods through chemical composition analysis were compared and the effect of heat inputs on dilution was researched. The results show that the proposed method fabricated mathematically agrees well with the definition of dilution in welding. Especially, by dilution increasing to a level higher than the critical value, it reveals the fact that a weld can be concentrated as well when the filler wire is rich in the same composition as the substrate does. Besides, the method demonstrates that the gross dilution for a bead is a combined result that is affected by each individual composition. However, whether a composition is diluted or concentrated, composition’s concentrations are propelled by the increase of heat input toward that of the original substrate. During the process, the dilution value changes sharply before the heat input reaches the transition point (TP) of 0.18 kJ/mm, while once the heat input is beyond TP, the dilution becomes stable.Keywords
Funding Information
- Guangdong Basic and Applied Basic Research (2019A1515110627)
- National Natural Science Foundation of China (51805099, 51875213)
This publication has 24 references indexed in Scilit:
- Effects of dilution on the hardness and residual stresses in multipass steel weldmentsInternational Journal of Pressure Vessels and Piping, 2020
- Effect of heat input on the Fe-based nanostructured weld overlayWelding International, 2015
- Effects of dilution and baseplate strength on stress distributions in multipass welds deposited using low transformation temperature filler alloysScience and Technology of Welding and Joining, 2014
- Effect of welding parameters on residual stresses in dissimilar joint of stainless steel to carbon steelJournal of Materials Science, 2010
- Microstructure and mechanical property of the fusion boundary region in an Alloy 182-low alloy steel dissimilar weld jointJournal of Materials Science, 2010
- Interface microstructure and mechanical properties of laser welding copper–steel dissimilar jointOptics and Lasers in Engineering, 2009
- Influence of microstructure and weld size on the mechanical behaviour of dissimilar AHSS resistance spot weldsScience and Technology of Welding and Joining, 2008
- Microstructure and failure behavior of dissimilar resistance spot welds between low carbon galvanized and austenitic stainless steelsMaterials Science and Engineering: A, 2008
- Steel to aluminium key-hole laser weldingMaterials Science and Engineering: A, 2007
- Prediction of Hardness of Spot Welds in SteelsWelding in the World, 2004