Modelling the deflection of rowing oar shafts
- 11 July 2016
- journal article
- research article
- Published by Taylor & Francis in Sports Biomechanics
- Vol. 16 (1) , 76-86
Abstract
The deflection of rowing oar shafts subjected to a static load was investigated. Two sets of sculling oars of different design stiffness were tested at three different lengths from 2.66 to 2.70 m. Loads up to 201 N were applied to the blade end of the oar shafts, and deflections were measured at six positions along the length of the shafts. The experimental results were compared with theoretical predictions obtained by modelling the oar shafts as homogenous end-loaded cantilever beams. The results show that the oar shafts are not uniform, in contradiction to the assumed model, but rather are most compliant near the sleeves and up to 80% stiffer towards the blades. The effect of oar shaft stiffness and length on the deflection angle at the blade end of the oar shaft was at most 1.18 ± 0.01°. The measured variation of stiffness along the shaft has implications for boat propulsion and rowing performance.Keywords
Funding Information
- Natural Sciences and Engineering Research Council of Canada
This publication has 13 references indexed in Scilit:
- The effects of oar-shaft stiffness and length on rowing biomechanicsProceedings of the Institution of Mechanical Engineers, Part P: Journal of Sports Engineering and Technology, 2015
- Modelling the effect of oar shaft bending during the rowing strokeProceedings of the Institution of Mechanical Engineers, Part P: Journal of Sports Engineering and Technology, 2011
- Estimation of the energy loss at the blades in rowing: Common assumptions revisitedJournal of Sports Sciences, 2010
- A three-dimensional model of the boat—oars—rower system using ADAMS and LifeMOD commercial softwareProceedings of the Institution of Mechanical Engineers, Part P: Journal of Sports Engineering and Technology, 2010
- Mechanics of a rowing stroke: Surge speed variations of a single scullProceedings of the Institution of Mechanical Engineers, Part P: Journal of Sports Engineering and Technology, 2009
- Simulating the fluid dynamic behaviour of oar blades in competition rowingProceedings of the Institution of Mechanical Engineers, Part P: Journal of Sports Engineering and Technology, 2009
- Effect of Oar Design on the Efficiency of the Rowing Stroke2007
- Effect of stroke rate on the distribution of net mechanical power in rowingJournal of Sports Sciences, 2007
- A simple 1+ dimensional model of rowing mimics observed forces and motionsHuman Movement Science, 2006
- A biomechanical review of factors affecting rowing performanceBritish Journal of Sports Medicine, 2002