Effects of processing history on the evolution of surface damage layer and dislocation substructure in large grain niobium cavities
Authors:
- D. KangDKD. Kang
- T. R. BielerTBT. R. Bieler
- C. ComptonCCC. Compton
Open Access
- 16 December 2015
- journal article
- research article
- Published by American Physical Society (APS) in Physical Review Special Topics - Accelerators and Beams
- Vol. 18 (12)
Abstract
Large grain niobium (Nb) is being investigated for fabricating superconducting radiofrequency cavities as an alternative to the traditional approach using fine grain polycrystalline Nb sheets. Past studies have identified a surface damage layer on fine grain cavities due to deep drawing and demonstrated the necessity for chemical etching on the surface. However, the origin of and depth of the damage layer are not well understood, and similar exploration on large grain cavities is lacking. In this work, electron backscatter diffraction (EBSD) was used to examine the cross sections at the equator and iris of a half cell deep drawn from a large grain Nb ingot slice. The results indicate that the damage (identified by a high density of geometrically necessary dislocations) depends on crystal orientations, is different at the equator and iris, and is present through the full thickness of a half cell in some places. After electron backscatter diffraction, the specimens were heat treated at or for two hours, and the same areas were reexamined. A more dramatic decrease in dislocation content was observed at the iris than the equator, where some regions exhibited no change. The specimens were then etched and examined again, to determine if the subsurface region behaved differently than the surface. Little change in the dislocation substructure was observed, suggesting that the large grain microstructure is retained with a normal furnace anneal.
Keywords
Funding Information
- U.S. Department of Energy (DE-SC0009962)
This publication has 14 references indexed in Scilit:
- Effect of high temperature heat treatments on the quality factor of a large-grain superconducting radio-frequency niobium cavityPhysical Review Special Topics - Accelerators and Beams, 2013
- Development of large grain cavitiesPhysical Review Special Topics - Accelerators and Beams, 2013
- Characterization of etch pits found on a large-grain bulk niobium superconducting radio-frequency resonant cavityPhysical Review Special Topics - Accelerators and Beams, 2010
- Evaluation of the propensity of niobium to absorb hydrogen during fabrication of superconducting radio frequency cavities for particle acceleratorsJournal of Research of the National Institute of Standards and Technology, 2010
- Physical and mechanical metallurgy of high purity Nb for accelerator cavitiesPhysical Review Special Topics - Accelerators and Beams, 2010
- The role of near-surface dislocations in the high magnetic field performance of superconducting niobium cavitiesSuperconductor Science and Technology, 2010
- Effects of Elastic Modulus on Deformation and Recrystallization of High Purity Nb2008
- Physical properties and structure of large grain/single crystal niobium for superconducting RF cavitiesJournal of Physics: Conference Series, 2008
- Development of Large Grain/Single Crystal Niobium Cavity Technology at Jefferson LabAIP Conference Proceedings, 2007
- Advances in Automatic EBSP Single Orientation MeasurementsTexture, Stress, and Microstructure, 1993