Effect of partial substitution of Ge4+ for Zn2+ on the microstructure and temperature stability of Mn-Zn ferrites
Authors:
- 1 May 1990
- journal article
- research article
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 67 (9) , 5506-5508
Abstract
The effects of substitution of GeO2 for ZnO on the microstructure and magnetic properties of Mn‐Zn ferrite have been studied. Results suggest that, to a very limited extent, by the substitution of Ge and a proper choice of sintering condition, good temperature coefficients can be obtained in a temperature range from 20 to 80 °C. Experimental results show that the substitution of GeO2 promotes discontinuous grain growth, and the lattice parameter is slowly reduced due to the substitution of from 0.5 to 2.0 mol % GeO2 for ZnO. The temperature coefficient is extremely process sensitive. For appropriate Ge substitution (0.5%), optimum initial permeability and the temperature coefficient are dependent on the sintering conditions. Samples with 0.5 mol % GeO2 sintered at 1290 °C using a rapid heating rate and short‐time sintering yielded the best temperature coefficient of 0.1×10−6 °C−1 over the range 20–80 °C.Keywords
This publication has 3 references indexed in Scilit:
- Effects of additions of TiO2, SnO2, Ga2O3, and MgO on the phase equilibria, stoichiometry, and lattice parameter of Ni0.89Fe2.11O4Journal of Solid State Chemistry, 1980
- Effect of doping a Mn-Zn ferrite with GeO2and SnO2IEEE Transactions on Magnetics, 1980
- High-permeability MnZn ferrites with flat µ-T curvesIEEE Transactions on Magnetics, 1968