Induction heating with the ring effect for injection molding plates
Authors:
- Hsuan-Liang LinHLHsuan-Liang Lin
- Shia-Chung ChenSCShia-Chung Chen
- Ming-Chang JengMJMing-Chang Jeng
- Pham Son MinhPMPham Son Minh
- Jen-An ChangJCJen-An Chang
- Jiun-Ren HwangJHJiun-Ren Hwang
- 1 April 2012
- journal article
- Published by Elsevier in International Communications in Heat and Mass Transfer
- Vol. 39 (4) , 514-522
Abstract
No abstract availableKeywords
Funding Information
- Ministry of Economic Affairs
- Ministry of Education
- National Science Council
This publication has 12 references indexed in Scilit:
- Gas-assisted mold temperature control for improving the quality of injection molded parts with fiber additivesInternational Communications in Heat and Mass Transfer, 2011
- Rapid mold temperature control in injection molding by using steam heatingInternational Communications in Heat and Mass Transfer, 2010
- Feasibility evaluation of gas-assisted heating for mold surface temperature control during injection molding processInternational Communications in Heat and Mass Transfer, 2009
- Mold temperature variation for assisting micro-molding of DVD micro-featured substrate and dummy using pulsed coolingSensors and Actuators A: Physical, 2009
- Variable mold temperature to improve surface quality of microcellular injection molded parts using induction heating technologyAdvances in Polymer Technology, 2008
- Micro-injection molding with the infrared assisted mold heating systemMaterials Science and Engineering: A, 2007
- Simulation of infrared rapid surface heating for injection moldingInternational Journal of Heat and Mass Transfer, 2006
- Rapid mold temperature variation for assisting the micro injection of high aspect ratio micro-feature parts using induction heating technologyJournal of Micromechanics and Microengineering, 2006
- High‐frequency proximity heating for injection molding applicationsPolymer Engineering & Science, 2006
- Dynamic mold surface temperature control using induction heating and its effects on the surface appearance of weld lineJournal of Applied Polymer Science, 2006