Variable speed constant frequency diesel power conversion system using doubly fed induction generator (DFIG)
Authors:
- 1 June 2008
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE) in 2008 IEEE Power Electronics Specialists Conference
- No. 02759306,p. 2728-2734
Abstract
Most of the diesel generators (DG) set used in remote areas runs at constant speed to produce ac output power with constant voltage and constant frequency. In remote areas the peak demand typically occurs only for a few hours in the evening. Therefore the DG set has to be heavily over-sized in relation to the prevalent load conditions. However prolonged light load operation results in poor fuel efficiency and excessive maintenance problems. In this paper, a variable speed diesel power generation system using a DFIG is presented. The control strategy for the diesel engine enables it to operate below and above the synchronous speed according to load demand. Simulation results of the dynamic system and preliminary experimental results based on a 15 kW prototype are included.Keywords
This publication has 6 references indexed in Scilit:
- Wind–Diesel Generation Using Doubly Fed Induction MachinesIEEE Transactions on Energy Conversion, 2008
- Double-fed induction generator control for variable speed wind power generationElectric Power Systems Research, 2006
- MRAS Observer for Sensorless Control of Standalone Doubly Fed Induction GeneratorsIEEE Transactions on Energy Conversion, 2005
- Ridethrough of Wind Turbines with Doubly-Fed Induction Generator During a Voltage DipIEEE Transactions on Energy Conversion, 2005
- A "power-mapping" variable-speed control technique for a constant-frequency conversion system powered by a IC engine and PM generator2002
- A simple position-sensorless algorithm for rotor-side field-oriented control of wound-rotor induction machineIEEE Transactions on Industrial Electronics, 2001