A review on the science of plastic deformation in laser-based additively manufactured steel
Authors:
- 27 April 2022
- journal article
- review article
- Published by Springer Nature in Journal of Materials Science
- Vol. 57 (24) , 10803-10835
Abstract
No abstract availableKeywords
Funding Information
- National Natural Science Foundation of China (U52071173)
- Science and Technology Innovation Commission of Shenzhen (JCYJ20210324120209026, Project No. KQTD2019092917250571)
This publication has 228 references indexed in Scilit:
- Tailoring the Mechanical Properties of a Twinning-Induced Plasticity Steel by Retention of Deformation Twins During Heat TreatmentMetallurgical and Materials Transactions A, 2013
- Crystal plasticity modeling of texture development and hardening in TWIP steelsActa Materialia, 2012
- Stacking fault energy and plastic deformation of fully austenitic high manganese steels: Effect of Al additionMaterials Science and Engineering: A, 2010
- Transformation potential predictions for the stress-induced austenite to martensite transformation in steelActa Materialia, 2010
- Fabrication of Fe–Cr–Al Oxide Dispersion Strengthened PM2000 Alloy Using Selective Laser MeltingAdvanced Engineering Materials, 2009
- Experimental investigation into selective laser melting of austenitic and martensitic stainless steel powder mixturesProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2009
- Effect of the Zener–Hollomon parameter on the microstructures and mechanical properties of Cu subjected to plastic deformationActa Materialia, 2009
- Analysis of the tensile behavior of a TWIP steel based on the texture and microstructure evolutionsMaterials Science and Engineering: A, 2009
- Analysis of the γ–ɛ–α′ variant selection induced by 10% plastic deformation in 304 stainless steel at −60°CMaterials Science and Engineering: A, 2007
- The influence of inclusion chemical composition on weld metal microstructureJournal of Materials Engineering, 1987