Effects of sintering temperature on physical and compositional properties of α-tricalcium phosphate foam
Authors:
- Melvin L. MunarMMMelvin L. Munar
- Michito MarutaMMMichito Maruta
- Shigeki MatsuyaSMShigeki Matsuya
- Kunio IshikawaKIKunio Ishikawa
- 1 January 2010
- journal article
- research article
- Published by Japanese Society for Dental Materials and Devices in Dental Materials Journal
- Vol. 29 (2) , 154-159
Abstract
Effects of sintering temperature on the physical and compositional properties of alpha-TCP foam fabricated using the polyurethane foam method were examined. When a polyurethane foam coated with alpha-TCP slurry was sintered at 1,400-1,550 degrees C, alpha-TCP foam having basically the same fully interconnected porous structure was produced although shrinkage occurred with increasing sintering temperature. On porosity of the alpha-TCP foam, a higher foam porosity of 95% was obtained when sintered at 1,400 degrees C as compared to the 90% porosity obtained at a higher sintering temperature of 1,550 degrees C. Further, at 1,500 degrees C or higher temperature, frame became dense with disappearance of micropores. On compressive strength, it increased from approximately 50 to 250 kPa when sintering temperature was increased from 1,400 to 1,550 degrees C. Nonetheless, no compositional changes were observed even when the alpha-TCP foam was cooled in the furnace without quenching process. In light of the results obtained, it was concluded that alpha-TCP foam fabricated using the polyurethane method was useful as a bone substitute and/or scaffolding material for tissue engineering. Besides, alpha-TCP foam could be useful as a precursor for the fabrication of other calcium phosphate foams.Keywords
This publication has 17 references indexed in Scilit:
- Modelling the mechanical properties of microporous and macroporous biphasic calcium phosphate bioceramicsJournal of the European Ceramic Society, 2006
- Macroporous calcium phosphate glass-ceramic prepared by two-step pressing technique and using sucrose as a pore formerJournal of Materials Science: Materials in Medicine, 2005
- Synthesis of porous hydroxyapatites by combination of gelcasting and foams burn out methodsJournal of Materials Science: Materials in Medicine, 2002
- Porous HA ceramic for bone replacement: Role of the pores and interconnections – experimental study in the rabbitJournal of Materials Science: Materials in Medicine, 2001
- Potential use of gelcasting hydroxyapatite porous ceramic as an implantable drug delivery system☆International Journal of Pharmaceutics, 2001
- Osteoconduction at porous hydroxyapatite with various pore configurationsBiomaterials, 2000
- Production of porous hydroxyapatite by the gel-casting of foams and cytotoxic evaluationJournal of Biomedical Materials Research, 2000
- Quantification of bone ingrowth within bone-derived porous hydroxyapatite implants of varying densityJournal of Materials Science: Materials in Medicine, 1999
- Role of interconnections in porous bioceramics on bone recolonization in vitro and in vivoJournal of Materials Science: Materials in Medicine, 1999
- Fabrication of hydroxyapatite ceramic with controlled porosityJournal of Materials Science: Materials in Medicine, 1997