Experimental Study of Mechanical Properties of 30SiMn2MoVA Steel Gun Barrel Processed by Cold Radial Forging
- 5 August 2020
- journal article
- research article
- Published by ASME International in Journal of Pressure Vessel Technology
- Vol. 143 (1)
Abstract
This work focused on the mechanical properties of 30SiMn2MoVA high strength steel gun barrel processed by cold radial forging. Three states of the tube made of this material (the state without forging, the as-forged state without annealing, and the as-forged state with annealing) were chosen to compare the axial and circumferential mechanical properties. As a result, anisotropy was found at as-forged state. The circumferential mechanical properties were inferior to the axial. The circumferential yield and tensile strength were about 150 MPa lower than the axial after forging, and the axial elongation was 155% higher than the circumferential. Even after annealing, the circumferential elongation cannot be restored to the same level as the state without forging. The reasons for anisotropy were investigated by the microstructure. The banded structure along the axial direction was observed in the forged barrel. Meanwhile, the crystalline grains of the forged gun barrel had the highest intensity of {111}〈110〉 texture which meant the grains had obvious preferential orientation. The relationship between crystallographic texture and yield strength was analyzed based on the Schmid factor. Additionally, the elastic limit internal pressure of anisotropic gun barrel was calculated, and it was lower than that under isotropic condition.Keywords
This publication has 16 references indexed in Scilit:
- Effect of Crystallographic Texture on Anisotropy of Yield Strength in X100 Pipeline SteelJournal of Iron and Steel Research International, 2013
- Experimental Study of the Evolution of Plastic Anisotropy in 5754 Al-Mg Cold Rolled SheetsExperimental Techniques, 2012
- Three-Dimensional Nonlinear Finite Element Analysis of Hot Radial Forging Process for Large Diameter TubesMaterials and Manufacturing Processes, 2010
- Numerical analysis of diffuse and localized necking in orthotropic sheet metalsInternational Journal of Plasticity, 2007
- A dislocation density based constitutive law for BCC materials in crystal plasticity FEMComputational Materials Science, 2007
- Texture and anisotropyReports on Progress in Physics, 2004
- Elasto-viscoplastic constitutive equations for polycrystalline metals: Application to tantalumJournal of the Mechanics and Physics of Solids, 1998
- Modelling flow stress anisotropy caused by deformation induced dislocation boundariesActa Materialia, 1997
- Measurement and prediction of plastic anisotropy in deep-drawing steelsMetallurgical Transactions A, 1990
- Orientation distribution, elastic and plastic anisotropy in stabilized steel sheetJournal of Applied Crystallography, 1969