Experimental Research of the Initial Temperature and Additives Effect on the Ignition and Combustion Mechanisms of Composite Liquid Fuel in a High-Temperature Oxidizer
Open Access
- 9 March 2023
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 13 (6) , 3501
Abstract
Composite fuel is a promising energy source that allows for solving the problems of waste disposal with energy generation. Such fuel is the most accessible fuel and is cheap in comparison with fossil fuels widely used in industrial thermal power engineering. This paper presents the results of experimental studies on the effect of the initial temperature and the addition of combustible liquids and solid components on the ignition characteristics of composite fuel single droplets. Composite liquid fuels were prepared using the main components: bituminous coal, coal processing waste (filter cake), rapeseed oil, turbine oil, and water. The research was carried out for fuel droplets with an initial temperature from −60 to +60 and an ambient temperature from 700 to 1000 °C. The differences in the ignition delay times at conditions close to the limiting ones were 2–3.5 times. A promising direction for intensifying the processes of the ignition and combustion of composite liquid fuels under relatively intense heating is self-grinding into a large number of small fragments up to complete disintegration due to the dispersion effect. It has been experimentally found that the addition of highly flammable liquids (gasoline, kerosene, diesel fuel, formic acid) to the fuel composition in an amount of 5% is characterized by an intensification of ignition and burnout of droplets by about two times. The ignition delay time is reduced by 20–40%, while the size of the dispersion area is increased by 20–70%. The addition of formic acid to the composite fuel has a positive effect on the main ignition characteristics from 5 to 50%, and the addition of a similar amount of diesel fuel by 20–64%.Keywords
Funding Information
- Tomsk Polytechnic University (Priority-2030-NIP/EB-03 8-1308-2022)
This publication has 35 references indexed in Scilit:
- A review on thermo-chemical characteristics of coal/biomass co-firing in industrial furnaceJournal of the Energy Institute, 2018
- Perspectives of the Use of Rapeseed Oil for the Doping of Waste-Based Industrial FuelEnergy & Fuels, 2017
- Experimental study on initial temperature influence on flame spread characteristics of diesel and gasoline–diesel blendsFuel, 2016
- EXPERIMENTAL INVESTIGATION OF THERMAL CONDUCTIVITY AND HEAT CAPACITY OF COAL-WATER FUELInternational Journal of Energy for a Clean Environment, 2016
- A combined cycle plant with air and fuel recuperator for captive power application, Part 1: Performance analysis and comparison with non-recuperated and gas turbine cycle with only air recuperatorEnergy Conversion and Management, 2014
- Initial fuel temperature effects on burning rate of pool fireJournal of Hazardous Materials, 2011
- Basic fuel properties of rapeseed oil-higher alcohols blendsFuel, 2011
- Characteristics of co-combustion and kinetic study on hydrothermally treated municipal solid waste with different rank coals: A thermogravimetric analysisApplied Energy, 2010
- Modelling of droplet burning for rapeseed oil as liquid fuelRenewable Energy and Power Quality Journal, 2007
- The solubility of water in edible oils and fatsJournal of the American Oil Chemists' Society, 1968