Comparative study of materials for friction pairs in a new high water-based hydraulic motor with low speed and high pressure
- 14 January 2019
- journal article
- research article
- Published by Emerald Publishing in Industrial Lubrication and Tribology
- Vol. 71 (1) , 164-172
Abstract
Aiming at improving the mechanical efficiency, the applicability and the working life of high water-based hydraulic motor (HWBHM) under working conditions at low speed and high pressure, the friction performance of different matching materials for piston slipper – crankshaft pair with high water-based hydraulic fluid (HWBHF) under working conditions at low speed and high pressure – were studied. The friction experiments for different materials (316L, 316L with surface coating OVINO – tetrahedral amorphous carbon [TAC; 316L-TAC] – 316L with surface coating OVINO-graphite intercalated compound [GIC; 316L-GIC] and polyetheretherketone [PEEK] reinforced with 30 per cent carbon fiber [PEEK-30CF]) under HWBHF lubrication were implemented on a pin-disk friction abrasion machine to determine the variations of coefficient of friction (CoF) and wear rate for each matching materials. In addition, the roughness and the morphology of worn surface of different matching materials were quantitatively characterized. The study revealed that material combinations have different friction performances. Test results showed that the abrasion of matching type stainless steel (SS) and SS is rather serious, and the method of surface coating could improve the friction performance of SS when friction with other materials. For matching type of SS with surface treatment (SS-ST) and SS-ST, 316L-GIC and 316L-GIC have relatively stable CoF, and the wear rate was smaller than other matching materials, while 316L-TAC and 316L-TAC has the smaller CoF than that of 316L-GIC. Matching materials 316L-GIC with PEEK-30CF of matching type SS-ST and PEEK-30CF has more stable COF and better wear resistance than those of other matching materials. This research has laid a foundation for the improvement of service life and working efficiency of friction pair in HWBHM under working conditions at low speed and high pressure.Keywords
This publication has 17 references indexed in Scilit:
- Load Capacity and Durability of H-DLC Coated Hydrodynamic Thrust BearingsJournal of Tribology, 2011
- Improvement in the tribological performances of Si3N4, SiC and WC by graphite-like carbon films under dry and water-lubricated sliding conditionsSurface and Coatings Technology, 2011
- Effects of sliding velocity and applied load on the tribological mechanism of amorphous poly-ether–ether–ketone (PEEK)Tribology International, 2008
- Tribological study on hydrostatic slipper bearing with annular orifice damper for water hydraulic axial piston motorTribology International, 2006
- Comparative investigation on the wear and transfer behaviors of carbon fiber reinforced polymer composites under dry sliding and water lubricationComposites Science and Technology, 2005
- Wear properties and mechanisms of nylon and carbon‐fiber‐reinforced nylon in dry and wet conditionsJournal of Applied Polymer Science, 2004
- Research on materials of piston and cylinder of water hydraulic pumpIndustrial Lubrication and Tribology, 2003
- Effect of carbon fibre reinforcement in the frictional behaviour of Peek in a water lubricated environmentWear, 2001
- Tribological performance of different DLC coatings in water-lubricated conditionsWear, 2001
- Effect of temperature on the friction and wear of heat‐resistant polymer‐based compositesJournal of Synthetic Lubrication, 1992