Studies on the melt flow behavior of thermoplastic elastomers from polypropylene—Natural rubber blends
Authors:
- 1 July 1985
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 25 (10) , 630-634
Abstract
The melt flow behavior of thermoplastic polypropylenenatural rubber blends has been evaluated with specific reference to the effects of blend ratio, extent of dynamic crosslinking of the rubber phase and temperature, on viscosity, flow behavior index, and deformation of the extrudate. The proportion of rubber in the blend and the extent of dynamic crosslinking of the rubber phase were found to have profound influence on the viscosity of the blends at lower shear stresses. But at higher shear stresses, the effect of blend ratio on viscosity was comparatively less for the uncrosslinked blends than that for the crosslinked blends. At lower shear stress, the viscosity of the blend increased with increase in degree of crosslinking but at higher shear stress, the effect of crosslinking on viscosity was found to vary depending on the ratio of the plastic and rubber components in the blend. The deformation of the extrudates was also very much dependent on both blend ratio and degree of crosslinking.Keywords
This publication has 27 references indexed in Scilit:
- Melt rheology of polymer blends the morphology feedbackPolymer Engineering & Science, 1983
- Melt flow of polymer blendsPolymer Engineering & Science, 1983
- Effect of Gel and Nonrubber Constituents on the Extrusion Properties of Guayule RubberRubber Chemistry and Technology, 1983
- Experimental Studies of the Influence of Particle and Fiber Reinforcement on the Rheological Properties of Polymer MeltsRubber Chemistry and Technology, 1980
- Rubber-Thermoplastic Compositions. Part II. NBR-Nylon Thermoplastic Elastomeric CompositionsRubber Chemistry and Technology, 1980
- Rubber-Thermoplastic Compositions. Part I. EPDM-Polypropylene Thermoplastic VulcanizatesRubber Chemistry and Technology, 1980
- An experimental study of the influence of carbon black on the rheological properties of a polystyrene meltPolymer Engineering & Science, 1979
- High‐density polyethylene melt elasticity—some anomalous observations on the effects of molecular structureJournal of Applied Polymer Science, 1975
- Rheology of Elastomer BlendsRubber Chemistry and Technology, 1973
- A rheological characterization of SBS block copolymersJournal of Applied Polymer Science, 1970