Strength Measurement of Concrete Using Different Cylinder Sizes: A Statistical Analysis
Author:
- 1 June 1994
- journal article
- Published by ASTM International in Cement, Concrete and Aggregates
- Vol. 16 (1) , 21-30
Abstract
Literature was analyzed to determine the relationship between strength of 150-mm (6 in.) diameter cylinders and smaller 100-mm (4 in.) and 75-mm (3 in.) diameter cylinders. The precision of measurement of strength when smaller cylinders are used was also examined. Almost 8000 cylinder strengths ranging from less than 20 MPa to greater than 100 MPa were analyzed. Results show: (1) over all strength ranges the coefficients of variation of strength (CV) for 100- and 150-mm cylinders are equivalent, (2) For 75-mm cylinders with strengths in the 20 to 60 MPa range, the mean CV is 5.2%, significantly higher than a mean CV of 3.0% for both 100- and 150-mm cylinders, (3) for 100- or 150-mm cylinders, the CV is significantly higher for strengths less than 60 MPa (3.0%) than for strengths greater than 60 MPa (1.8%), (4) within the range 20 to 100 MPa, the expected strength using 100-mm plastic or steel molds is 5% greater than if 150-mm plastic or steel molds are used.Keywords
This publication has 4 references indexed in Scilit:
- The Effect of Mold Size and Mold Material on Compressive Strength Measurement Using Concrete CylindersCement, Concrete and Aggregates, 1994
- Evaluation of Cylinder Size and Capping Method in Compression Strength Testing of ConcreteCement, Concrete and Aggregates, 1993
- ARE 4 x 8-inch concrete cylinders as good as 6 x 12-inch cylinders for quality control of concrete?1972
- A General Relation for Strengths of Concrete Specimens of Different Shapes and SizesACI Journal Proceedings, 1966