Dynamic force spectroscopy using cantilever higher flexural modes
Authors:
- 27 August 2007
- journal article
- conference paper
- Published by AIP Publishing in Applied Physics Letters
- Vol. 91 (9) , 093120
Abstract
By means of force spectroscopy measurements performed with the cantilever first and second flexural modes under the frequency modulation detection method, the authors corroborate the validity of the relation between tip-surface interaction force and frequency shift for force spectroscopy acquisition using higher cantilever eigenmodes. They estimate a cantilever effective stiffness for the second eigenmode 73 times larger than the static stiffness. This large effective stiffness enables them to perform force spectroscopy with a cantilever oscillation amplitude as small as . The authors provide experimental evidence that, at such small values, normalized frequency shift curves deviate from a scaling and the signal-to-noise ratio is considerably enhanced.
Keywords
This publication has 26 references indexed in Scilit:
- Mechanism for Room-Temperature Single-Atom Lateral Manipulations on Semiconductors using Dynamic Force MicroscopyPhysical Review Letters, 2007
- Chemical identification of individual surface atoms by atomic force microscopyNature, 2007
- Real topography, atomic relaxations, and short-range chemical interactions in atomic force microscopy: The case of the surfacePhysical Review B, 2006
- Single Atomic Contact Adhesion and Dissipation in Dynamic Force MicroscopyPhysical Review Letters, 2006
- Atom inlays performed at room temperature using atomic force microscopyNature Materials, 2005
- Advances in atomic force microscopyReviews of Modern Physics, 2003
- Dynamic atomic force microscopy methodsSurface Science Reports, 2002
- Noncontact Atomic Force Microscopy2002
- Quantitative Measurement of Short-Range Chemical Bonding ForcesScience, 2001
- Frequency modulation detection using high-Q cantilevers for enhanced force microscope sensitivityJournal of Applied Physics, 1991